| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Transfer Case Sight Tube http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=37859 |
Page 1 of 1 |
| Author: | jeepkj02 [ Tue Dec 02, 2008 11:58 am ] |
| Post subject: | Transfer Case Sight Tube |
I was searching the net for some CJ tech/builds and found this sight tube someone made for the dana 300. 
http://homepage.mac.com/rv6a/d300mods.html So then I decided to look to see if someone made one for the NV231 and found this thread on JU 
http://www.jeepsunlimited.com/forums/showthread.php?t=903991 Thinking of doing it to my t-case next time I need to change the fluid. Easy way to check the level and condition of the fluid. What do you think??? |
|
| Author: | Chief BK [ Tue Dec 02, 2008 2:28 pm ] |
| Post subject: | |
Great find! |
|
| Author: | Xodius [ Tue Dec 02, 2008 5:43 pm ] |
| Post subject: | |
That is a pretty darn good idea. Especially if you have skids...then you shouldnt have to worry about yanking that tub off. I am curious though...where would you tap to install it? |
|
| Author: | KJ Taz [ Tue Dec 02, 2008 6:03 pm ] |
| Post subject: | |
Its in the drain plug and the fill plug. Great idea! |
|
| Author: | jeepkj02 [ Wed Dec 03, 2008 12:48 pm ] |
| Post subject: | |
Anyone know the thread size of the fill and drain plug on the NP231??? |
|
| Author: | Maximum Carnage [ Wed Dec 03, 2008 12:57 pm ] |
| Post subject: | |
This is a sweet mod. |
|
| Author: | tjkoen01 [ Thu May 07, 2009 8:22 am ] |
| Post subject: | |
so has anyone done this yet? I have not been able to find fittings that fit the existing holes. |
|
| Author: | Albert [ Thu May 07, 2009 8:57 am ] |
| Post subject: | |
That is neat. The t-case is tucked up there pretty good and with a skid it shouldn't get snagged up or anything. I have been through some serious mud and the t-case seems to stay pretty clean compared to everything elce. I saw that done before somewhere. I think I would like to try that. Anyone know what size and where to get the fittings?? |
|
| Author: | Maximum Carnage [ Thu May 07, 2009 1:52 pm ] |
| Post subject: | |
tjkoen01 wrote: so has anyone done this yet? I have not been able to find fittings that fit the existing holes.
I looking into it but I too am unable to locate the proper fittings. I'm ready to give up. |
|
| Author: | tjkj2002 [ Thu May 07, 2009 2:41 pm ] |
| Post subject: | |
My new t-case will have a sight tube,then again it's standard on a AtlasII. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|