You can get a scanner that will read and clear codes for under $50
Check Harbor's Freight's number 94169
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| How can I reset fault codes? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=38165 |
Page 1 of 1 |
| Author: | Dutchy [ Fri Dec 12, 2008 5:57 am ] |
| Post subject: | How can I reset fault codes? |
I have 3 fault codes, I have dealt with the problems one by one and I did reset the settings by taking the battery clamps of for a couple of minutes. I also heard that after sixty starts the codes should wipe themselves but they don't. Any idea's how to clear the codes? |
|
| Author: | scoon [ Fri Dec 12, 2008 9:46 am ] |
| Post subject: | |
Hey there, I reset my codes by disconnecting the negative battery terminal and then applying the brake for 1 minutes. thanks. |
|
| Author: | trailman [ Fri Dec 12, 2008 11:53 am ] |
| Post subject: | |
I've reset mine by disconnecting the neg batt cable and going watch TV for a while, then reconnect later. |
|
| Author: | jeepkj02 [ Fri Dec 12, 2008 12:31 pm ] |
| Post subject: | |
scoon wrote: Hey there,
I reset my codes by disconnecting the negative battery terminal and then applying the brake for 1 minutes. thanks. Haven't heard that one. Just disconnect negative terminal for 10 minutes and reconnect. Or go to an auto parts store and ask them to clear the code. Or get a OBDII scanner for about $70 and do it yourself Clearing the code doesn't fix the problem. |
|
| Author: | Dutchy [ Sat Dec 13, 2008 5:39 am ] |
| Post subject: | |
Thanks, but all the above does not wipe the codes. I had the neg.battery pole off for 45 min and the codes are still there, I know the problems are fixed ,it's just the computer does not get it. |
|
| Author: | tjkj2002 [ Sat Dec 13, 2008 9:19 am ] |
| Post subject: | |
Dutchy wrote: Thanks, but all the above does not wipe the codes. What codes?
I had the neg.battery pole off for 45 min and the codes are still there, I know the problems are fixed ,it's just the computer does not get it. Some codes will not go away with pulling the battery terminal,some will.Depending on the codes you may have not gotten the problem fixed yet. |
|
| Author: | Joe Romas [ Mon Dec 15, 2008 10:13 am ] |
| Post subject: | |
You can get a scanner that will read and clear codes for under $50
Check Harbor's Freight's number 94169 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|