For those of you that have a trans skid plate, how much space is there between the pan and the plate?

_________________
2010 JK Sport 6spd

2002 Liberty Sport ---> SOLD

For Sale: Skid Row transmission skid plate and rear headrests


ABSENCE OF EVIDENCE IS NOT EVIDENCE OF ABSENCE

ohh yeah its a rfe45

_________________
2010 JK Sport 6spd

2002 Liberty Sport ---> SOLD

For Sale: Skid Row transmission skid plate and rear headrests


ABSENCE OF EVIDENCE IS NOT EVIDENCE OF ABSENCE

What year Libby? My MOPAR (2004) tranny skid had 2 tabs in the front that needed to be removed, then it fit like a glove.

_________________
07 Wrangler 4 door X.
Full skids, OME lift, PIAA bulbs, Hellas, 35's, 5.13s, EVAP skid, XRC 10 winch, XHD stubby, CB, BA rock rails, JKS discos and trac bars, Riddler covers, superchipped...

81' CJ5 Renegade with the Iron Duke, 2.5" Rusty's lift, JKS disconnects, Weber carb

RIP : 04 Liberty Sport Patriot Blue

2002. I just need t know if there is any space between the bottom of the pan and skid plate. the reason is i didn't think when i put in my drain plug and instead of putting it on the side of the pan i drilled the hole on the bottom so i dont know if i have enough space to install a skid plate.....

_________________
2010 JK Sport 6spd

2002 Liberty Sport ---> SOLD

For Sale: Skid Row transmission skid plate and rear headrests


ABSENCE OF EVIDENCE IS NOT EVIDENCE OF ABSENCE

Oh.....I will try and crawl under mine Sat @ work in the heat and check it out.

_________________
07 Wrangler 4 door X.
Full skids, OME lift, PIAA bulbs, Hellas, 35's, 5.13s, EVAP skid, XRC 10 winch, XHD stubby, CB, BA rock rails, JKS discos and trac bars, Riddler covers, superchipped...

81' CJ5 Renegade with the Iron Duke, 2.5" Rusty's lift, JKS disconnects, Weber carb

RIP : 04 Liberty Sport Patriot Blue

my 04 has plenty of room, even if I would of put a drain plug in a bad location

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Thanks guys. it sticks out about 3/4 in.

_________________
2010 JK Sport 6spd

2002 Liberty Sport ---> SOLD

For Sale: Skid Row transmission skid plate and rear headrests


ABSENCE OF EVIDENCE IS NOT EVIDENCE OF ABSENCE

On my 02 there is about 1/4" near the back of the pan and maybe 1/2" towards the front of the pan. I wouldn't bet on it fitting with a drain plug sticking out.

Then again, my skid plate has bent and bent back a few times over the years

_________________
02 KJ Limited w/ offroad pkg, Sunroof, NP 242
Moab with 255/70 Grabber AT2's
Tweaked Rusty's Coil Lift w/ OME LT shocks
Mopar skids & Rocky Road Supersliders
http://www.cardomain.com/id/bighause

Retired Jeeps - 84CJ, 90YJ, 97XJ, 86CJ

Just cut a small hole in that part of the skid plate

_________________

A new Mopar skid starts at ~1, 1 1/2 inches - (ridges)
after Steel Bender - it was about 1/2"
after Hells Revenge - it was an interference fit

and with the new tranny pan - I now have a SuperSkid
Will get it installed in the next week - I expect it to be closer - but more consistent.

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur