LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Front Wheel Bearing
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=39262		 Page 1 of 1
Author:  N / A [ Fri Jan 16, 2009 10:42 am ]
Post subject:  Front Wheel Bearing
I need to do a front wheel bearing, I haven't looked at it yet but are they pressed in? or is it just a whole assemble I need to take off? do i Need any special tools?

any brief description of the process?
Author:  Jeepjeepster [ Fri Jan 16, 2009 12:06 pm ]
Post subject: 
http://lostjeeps.com/forum/phpBB3/viewtopic.php?t=39169
Author:  N / A [ Sat Jan 17, 2009 1:48 pm ]
Post subject: 
that link really didn't give a lot of info.

I just finished taking the old on off, needed a 35mm for the hub nut and a E14 for the 3 bolts holding on the hub. Other then that it took under 10 mins to remove.
Author:  Jeepjeepster [ Sat Jan 17, 2009 2:01 pm ]
Post subject: 
tjkj2002 wrote:
tommudd wrote:
2006 KJ wrote:
not too hard to change one.. but you will need i believe a 12pt. or 8pt socket(i forget) to get 3 bolts out that go from behind the knuckle out towards the wheels. i had a slight vibration so i changed mine (passenger side) but it didnt help :( you have to change the knuckle to change the wheel bering


those bolts are a son of a gun to get out or at least they were on the one I did
Those bolts require a E12 or E14 Torx socket.The knuckle stays,the unit bearing with the hub is what's changed.


Figured tjkj summed it up pretty good.

Glad you got it out without any problems. :)
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/