Subject explains it all...need to replace it tomorrow but not sure where its at.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Crankshaft position sensor...where is it??? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=39928 |
Page 1 of 1 |
| Author: | NorCal KJ 707 [ Fri Feb 06, 2009 3:02 am ] |
| Post subject: | Crankshaft position sensor...where is it??? |
Subject explains it all...need to replace it tomorrow but not sure where its at.
|
|
| Author: | Wasatch15 [ Fri Feb 06, 2009 9:00 pm ] |
| Post subject: | |
The crankshaft position sensor on a 3.7L is mounted into the passenger rear side of the cylinder block, low just above the oil pan. It is positioned and bolted into a machined hole. After un-bolting carefully remove sensor from cylinder block in a rocking and twisting action. Clean out machined hole, apply a small amount of engine oil to sensor o-ring, install with slight rocking and twisting action. Before tightening mounting bolt be sure sensor is completely flush or damage to mounting tang will result....lather, rinse, repeat  
|
|
| Author: | NorCal KJ 707 [ Fri Feb 06, 2009 9:53 pm ] |
| Post subject: | |
Thanks a lot!!! I'll be tackling this tomorrow morning...sounds like its in a not so easy to reach spot. Maybe thats why its one of the cheaper sensors 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|