Subject explains it all...need to replace it tomorrow but not sure where its at.

_________________
2oo2 KJ LTD -- SOLD
OME-Rancho-Rusty's Lift, 15x7 Soft 8s w/ 31x10.50R15 BFG KM2s-Need to sell!!!

2009 PBM Pontiac G8 GT -- New Toy
Stock...for now

The crankshaft position sensor on a 3.7L is mounted into the passenger rear side of the cylinder block, low just above the oil pan. It is positioned and bolted into a machined hole. After un-bolting carefully remove sensor from cylinder block in a rocking and twisting action. Clean out machined hole, apply a small amount of engine oil to sensor o-ring, install with slight rocking and twisting action. Before tightening mounting bolt be sure sensor is completely flush or damage to mounting tang will result....lather, rinse, repeat

_________________
2002 Silver Sport 4x4 3.7L-5 Speed NV3550 Manual Transmission-NV231J TC-Frankenlift-AllJ Interior Rack-ARB Bumper-Hella Driving Lights-Electric Trailer Brake-Moog LBJs-JBA 4.5 UCAs-Detroit Trutrac (Front)-245/70/16 Dueler A/T Tires-Amsoil EaA201 Air Filter-Tom Woods Custom Front Drive Shaft-Rock Lizard Gecko HD Roof Rails-Onboard Co2

Thanks a lot!!! I'll be tackling this tomorrow morning...sounds like its in a not so easy to reach spot. Maybe thats why its one of the cheaper sensors

_________________
2oo2 KJ LTD -- SOLD
OME-Rancho-Rusty's Lift, 15x7 Soft 8s w/ 31x10.50R15 BFG KM2s-Need to sell!!!

2009 PBM Pontiac G8 GT -- New Toy
Stock...for now