Can I use steel wool on the parts that have surface rust, and then clean it up really well and spray on some rustoleum, or would it just come off?

Thanks

i used some sand paper i had layin around, it was actually for sanding wood

wiped it off on my shirt and sprayed it with black 2500F stovepipe paint

dried to a nice flat black, hasn't seemed to have came off except where metal to metal occurs

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632

I always use emery clothe. its basically sand paper but with a clothe backing. and then shot it with some brake clean.