| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| My car didnt shift.... http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=41069 |
Page 1 of 2 |
| Author: | Quicksilversurf917 [ Tue Mar 10, 2009 9:30 pm ] |
| Post subject: | My car didnt shift.... |
So I was on my way home from a friends house and I was doing 55 and some guy in an Ford Explorer decided to try and pass me.....well I tryed to match him and let him not get over Anybody have any ideas what it could have been, like if it was my stupid idea to hit the O/D? |
|
| Author: | JeepinJarhead03 [ Tue Mar 10, 2009 9:42 pm ] |
| Post subject: | |
was your transmission at it's normal operating temp? meaning had you been driving for awhile? |
|
| Author: | Quicksilversurf917 [ Tue Mar 10, 2009 10:00 pm ] |
| Post subject: | |
it was at its normal temp. and I make the same drive to my friends house almost every day bc my work is right by her house and its only a 25 mile drive each way |
|
| Author: | KJ kyle [ Tue Mar 10, 2009 10:48 pm ] |
| Post subject: | |
1st order of buisness.. you just killed a kitten. and about the transmission, why would you turn off the overdrive? i beleive overdrive is the final gear that you were trying to shift into... the reason for the off button is when you are towing, and the overdrive ratio is too high to handle the extra load. and if you didnt know, and overdrive gear is just a gear selection were the drive gear is smaller than the driven gear. |
|
| Author: | Quicksilversurf917 [ Tue Mar 10, 2009 10:52 pm ] |
| Post subject: | |
well usually when you turn O/D off your rpm's go longer (for towing) to get your speed up. and I was trying to get my speed going so the F****r couldnt pass me. |
|
| Author: | JeepinJarhead03 [ Tue Mar 10, 2009 10:59 pm ] |
| Post subject: | |
he was trying to shift back into 3rd, 6k rpm at 70 is 2nd gear, 3rd at 70 is 4kish more or less are you saying it didnt shift back to 3rd when you lifted off the skinny pedal a bit? shifts are crisper with the OD off and the TqC is a bit lazy with it on, the quicker shifts is probably what he was aiming for |
|
| Author: | JeepinJarhead03 [ Tue Mar 10, 2009 11:00 pm ] |
| Post subject: | |
by the way, if your car is acting funny when driving maybe you should drive your jeep instead |
|
| Author: | Quicksilversurf917 [ Tue Mar 10, 2009 11:01 pm ] |
| Post subject: | |
JeepinJarhead03 wrote: he was trying to shift back into 3rd, 6k rpm at 70 is 2nd gear, 3rd at 70 is 4kish more or less
are you saying it didnt shift back to 3rd when you lifted off the skinny pedal a bit? shifts are crisper with the OD off and the TqC is a bit lazy with it on, the quicker shifts is probably what he was aiming for yea you basically explained it all. But I lifted off the pedal when he got infront of me and I turned the O/D off right as I let go of the gas. |
|
| Author: | Quicksilversurf917 [ Tue Mar 10, 2009 11:04 pm ] |
| Post subject: | |
JeepinJarhead03 wrote: by the way, if your car is acting funny when driving maybe you should drive your jeep instead
SORRY I MENT JEEP lol. Im so out of it tonight..... |
|
| Author: | JeepinJarhead03 [ Tue Mar 10, 2009 11:31 pm ] |
| Post subject: | |
i'm a tad confused but i dont think it's all your fault, lets get everything straight you were driving a jeep took off o/d and floored it or something close to it it downshifted to 2nd , rpms hit 6kish he got infront of you and you lifted off the gas , turned OD back on and it didn't shift to 3rd or OD? or are you saying, prior to lifting off the gas, with it floored it wasn't shifting to 3rd? i typically stroke the pedal back to 3/4ths or so at 5500ish for the shift from 2nd to 3rd and then ease back in to about 4/5ths gradually until i'm past the point where it will downshift the 3.7, atleast with the 3.73 has about 1k worth of fairly useless rpm prior to redline and at those speeds it may have been having trouble reaching the shiftpoint at 100% throttle can you clarify any? |
|
| Author: | InCommando [ Wed Mar 11, 2009 12:19 am ] |
| Post subject: | |
The most obvious explanation is that kicking off o/d put your tranny into third, and with o/d off there was no where else for the tranny to go???? |
|
| Author: | JeepinJarhead03 [ Wed Mar 11, 2009 12:21 am ] |
| Post subject: | |
i'm willing to go run mine down the road right now to test it but i'm pretty sure he was in 2nd not 3rd |
|
| Author: | Quicksilversurf917 [ Wed Mar 11, 2009 7:00 am ] |
| Post subject: | |
JeepinJarhead03 wrote: i'm a tad confused but i dont think it's all your fault, lets get everything straight
you were driving a jeep took off o/d and floored it or something close to it it downshifted to 2nd , rpms hit 6kish he got infront of you and you lifted off the gas , turned OD back on and it didn't shift to 3rd or OD? or are you saying, prior to lifting off the gas, with it floored it wasn't shifting to 3rd? i typically stroke the pedal back to 3/4ths or so at 5500ish for the shift from 2nd to 3rd and then ease back in to about 4/5ths gradually until i'm past the point where it will downshift the 3.7, atleast with the 3.73 has about 1k worth of fairly useless rpm prior to redline and at those speeds it may have been having trouble reaching the shiftpoint at 100% throttle can you clarify any? After he got infront of me I just let go of the gas and turn the O/D back on and everything was perfectly normal after that. |
|
| Author: | dkcase [ Wed Mar 11, 2009 7:51 am ] |
| Post subject: | |
KJ kyle wrote: .... overdrive gear is just a gear selection were the drive gear is smaller than the driven gear.
Check this. Isn't this backwards ? |
|
| Author: | KJ kyle [ Wed Mar 11, 2009 8:19 am ] |
| Post subject: | |
yes i beleive it is. sorry, tuesday is dollar drafts.... |
|
| Author: | JeepinJarhead03 [ Wed Mar 11, 2009 1:35 pm ] |
| Post subject: | |
ah ok i understand now, i think your jeep was just having trouble reaching the 2nd to 3rd shift point, you just needed to back off the skinny pedal a bit for it to shift |
|
| Author: | CrossBones [ Wed Mar 11, 2009 1:39 pm ] |
| Post subject: | |
JeepinJarhead03 wrote: i'm a tad confused but i dont think it's all your fault, lets get everything straight
I'm not confused because it was his fault. I mean why do this to begin with? |
|
| Author: | JeepinJarhead03 [ Wed Mar 11, 2009 1:45 pm ] |
| Post subject: | |
Because he killed a Kitten |
|
| Author: | lil black liberty [ Wed Mar 11, 2009 1:47 pm ] |
| Post subject: | |
Quicksilversurf917 wrote: JeepinJarhead03 wrote: i'm a tad confused but i dont think it's all your fault, lets get everything straight you were driving a jeep took off o/d and floored it or something close to it it downshifted to 2nd , rpms hit 6kish he got infront of you and you lifted off the gas , turned OD back on and it didn't shift to 3rd or OD? or are you saying, prior to lifting off the gas, with it floored it wasn't shifting to 3rd? i typically stroke the pedal back to 3/4ths or so at 5500ish for the shift from 2nd to 3rd and then ease back in to about 4/5ths gradually until i'm past the point where it will downshift the 3.7, atleast with the 3.73 has about 1k worth of fairly useless rpm prior to redline and at those speeds it may have been having trouble reaching the shiftpoint at 100% throttle can you clarify any? After he got infront of me I just let go of the gas and turn the O/D back on and everything was perfectly normal after that. First off...You let a Ford Explorer beat you seriously?? Man you need to drop in a New Air Filter and get you a Flowmaster 40 with duals.. Hell I was keeping up with my Dad's 07 5.7L Dodge 1500 Hemi until I hit the speed limiter.. I eat mustangs and explorers for brunch now the fun part is trying to get a diesel powerstroke to race you and let them pass you at over 100mph and a Highway Patrol is right there watching him and gives him a ticket |
|
| Author: | JeepinJarhead03 [ Wed Mar 11, 2009 1:54 pm ] |
| Post subject: | |
You guys are wierd |
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|