common sources? got a thread of how to remove oem renny light bar shroud to check wiring gasket ?

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632

There are 4 TORX bolts,T25 or T27,on the back side of the lightbar cover that holds it on.Just remove those 4 bolts and lift cover off.

thanks, never had it off, didn't know if there was a trick to it, found a semi noticable amt of water in the carpet padding after i washed it the other day and I had been spraying the light bar to knock bugs off of it, usually don't have my light bar covers on so I usually don't bother with anything other than a light spray

come to think of it i have a busted drivers side door weather stripping slighly below the latch that has a chunk taken out about 4 - 5 inches long that has fully exposed the interior of the strip, wonder if water ran down in that and then found its way into the floor, seems more likley than the light bar...

where's a good place to get our weather stripping?

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632