LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Scan Gauge II and XGauge Data
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=41624		 Page 1 of 1
Author:  clreinstein [ Fri Mar 27, 2009 5:43 pm ]
Post subject:  Scan Gauge II and XGauge Data
What have people found the XGauge feature in the Scan Gauge II can read on the gas KJ's. The scan gauge website lists all the different data for vehicle specific gauges. From what ive read on LOST the Jeep uses a PCIbus with VPW. On the list the list from scan gauge it shows different data for gauges for GM VPW. Will this work or is my info wrong. I want to make sure I have the right info before I program anything and if the Jeep computer can be read for any of the Xgauges enhanced data.

Also does the scan gauge read fuel pressure or oil pressure for the KJ?
Author:  Jeepjeepster [ Fri Mar 27, 2009 9:01 pm ]
Post subject: 
Good question, I would be interested to know what other gauges you can add too.. Not sure if anyone will know though..

Ive only added the horse power gauge and its pretty useless. It gives a percent and it says 100% anytime Im giving it any amount of gas. Hopefully Im not making 100% of my hp at 2,500 rpms. :shock:
Author:  Sean [ Sat Mar 28, 2009 12:08 pm ]
Post subject: 
Same questions here - there is a website with a lot of information about the Liberty vehicle networks that is a good resource, however i have not yet figured out how to get custom parameters to show up in my scan gauge.

I would like to get engine oil temp and trans oil temp

http://www.kolumbus.fi/juha.niinikoski/ ... verter.htm
Author:  MP Jeeper [ Sun Mar 29, 2009 1:07 am ]
Post subject: 
i have programmed a couple of the X-guages and use them from time to time. It's been awhile though since i programmed them. Will look tomorrow, see what i came up with and post here.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/