What have people found the XGauge feature in the Scan Gauge II can read on the gas KJ's. The scan gauge website lists all the different data for vehicle specific gauges. From what ive read on LOST the Jeep uses a PCIbus with VPW. On the list the list from scan gauge it shows different data for gauges for GM VPW. Will this work or is my info wrong. I want to make sure I have the right info before I program anything and if the Jeep computer can be read for any of the Xgauges enhanced data.

Also does the scan gauge read fuel pressure or oil pressure for the KJ?

_________________
02 KJ

Good question, I would be interested to know what other gauges you can add too.. Not sure if anyone will know though..

Ive only added the horse power gauge and its pretty useless. It gives a percent and it says 100% anytime Im giving it any amount of gas. Hopefully Im not making 100% of my hp at 2,500 rpms.

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster

Same questions here - there is a website with a lot of information about the Liberty vehicle networks that is a good resource, however i have not yet figured out how to get custom parameters to show up in my scan gauge.

I would like to get engine oil temp and trans oil temp

http://www.kolumbus.fi/juha.niinikoski/ ... verter.htm

_________________
2006 Renegade 4x4

i have programmed a couple of the X-guages and use them from time to time. It's been awhile though since i programmed them. Will look tomorrow, see what i came up with and post here.

_________________
'04 Renny
Mod's: See Avatar
Conquests: Poughkeepsie Gulch, Governor's Basin, Black Bear/Imogene/Engineer/Cinnamon pass, Coal Creek OHV, Badlands OHV, S.M.O.R.R., K-Rocks, Parent's driveway