yeah, the threads.... I got a 1/4"-28 taper thread from napa since it was the closest one they had, but it doesn't seem to fit as snug
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Grease fittings on Al's 4th Gen A-Arms http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=41886 |
Page 1 of 1 |
| Author: | BeepBeepJeepJeep [ Sat Apr 04, 2009 1:34 pm ] |
| Post subject: | Grease fittings on Al's 4th Gen A-Arms |
Can anyone tell me what size they are? Thanks, Bill |
|
| Author: | Joe Jeeper [ Sat Apr 04, 2009 6:55 pm ] |
| Post subject: | |
Do you mean the threads? I wanted to get a 90 degree one and had no luck. |
|
| Author: | dieselenthusiast [ Sat Apr 04, 2009 8:14 pm ] |
| Post subject: | |
Joe, you got a new JEEP! |
|
| Author: | BeepBeepJeepJeep [ Sat Apr 04, 2009 8:50 pm ] |
| Post subject: | |
yeah, the threads.... I got a 1/4"-28 taper thread from napa since it was the closest one they had, but it doesn't seem to fit as snug
|
|
| Author: | tjkj2002 [ Sat Apr 04, 2009 11:12 pm ] |
| Post subject: | |
BeepBeepJeepJeep wrote: yeah, the threads.... I got a 1/4"-28 taper thread from napa since it was the closest one they had, but it doesn't seem to fit as snug They should be 1/4-24 thread.
|
|
| Author: | Jeep4me99 [ Mon Apr 06, 2009 7:40 am ] |
| Post subject: | |
i e-mailed JBA about this recently. Marlin said they are 1/4-28 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|