Here's my howto, maybe you've seen it before.
http://www.jeepkj.com/forum/showthread.php?t=34988
And here is my nutzert tool.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Renny light bar help http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=43126 |
Page 1 of 1 |
| Author: | weston02kj [ Wed May 13, 2009 10:10 am ] |
| Post subject: | Renny light bar help |
does anyone know where to get the "nutsertz" or has anyone used anything instead to mount the bar to your roof? I bought a used bar and it didnt come with all that. |
|
| Author: | hallb4 [ Thu May 21, 2009 1:26 pm ] |
| Post subject: | |
This is what the 2005 Parts List doc says: Part # | Name | Info 6503 952 | SCREW | Pan Head, M6x1.0x17.00 6100 876 | WASHER | Flat, M6.82x17.00x1.75 6504 710 | NUT/RIVET | M6x1.00x13.50 I can try to get a screenshot of the page if you want but it might be easier (and more helpful to you) if you can track down the parts list pdf file. |
|
| Author: | JL Rockies [ Thu May 21, 2009 1:44 pm ] |
| Post subject: | |
You have to order from the dealer. |
|
| Author: | 2006 KJ [ Thu May 21, 2009 2:00 pm ] |
| Post subject: | |
we have a nutzert tool that came with a many different sizes of nutzerts.. the tool makes installing them SOOOOO much easier than cranking them with a ratchet.. the tool is a large squeezing boltcutter looking thing that acts like a big river gun. this is what ours is.. http://www.findtheneedle.co.uk/images/p ... /78141.jpg |
|
| Author: | tonycrd [ Fri May 22, 2009 7:49 am ] |
| Post subject: | |
Here's my howto, maybe you've seen it before. http://www.jeepkj.com/forum/showthread.php?t=34988 And here is my nutzert tool.
|
|
| Author: | Terdl76 [ Fri May 22, 2009 12:32 pm ] |
| Post subject: | |
as far as the tool im not sure, but you can use a peice of all-thread and same size nut. the nutserts are avalible at lowes in the specialty hardware section. |
|
| Author: | JMM [ Wed Jun 24, 2009 5:08 am ] |
| Post subject: | |
This may still be of interest to you - I picked one of these up "39214 Marson Steel Klik Thread-Sert Kit (39214)" for like 60 bucks from: http://www.blindrivetsupply.com/ and it is amazing how handy it is... Then went back and picked up the metric conversion kit for it so now I can do metric inserts as well. You can also see some products at: http://www.nutty.com/threatsert.shtml |
|
| Author: | Jeep Dawg [ Wed Jun 24, 2009 12:33 pm ] |
| Post subject: | |
I tacked welded mine into place for added tightness. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|