Clutch replacement imminent

BeepBeepJeepJeep · **Posted:** Sun May 31, 2009 11:16 am

My throwout bearing is starting to get noisy, so I figure I might as well replace the entire clutch in a few months. Where should I buy the kit? Should I get it directly from mopar or is there an aftermarket brand that will do just as well for less?

Thanks,
Bill

tjkj2002 · **Posted:** Sun May 31, 2009 8:05 pm

If your throwout bearing is starting to make noise it's best to get the whole thing replaced ASAP.If that bearing freezes it can make the job alot harder and could make it alot more expensive also.

BeepBeepJeepJeep · **Posted:** Thu Jun 04, 2009 7:03 pm

tjkj2002 wrote:

If your throwout bearing is starting to make noise it's best to get the whole thing replaced ASAP.If that bearing freezes it can make the job alot harder and could make it alot more expensive also.

Well it started making a lot more noise today. Jeep isn't moving till I get a replacement. Should I go to Chrysler or what?

How about this: http://tinyurl.com/ordoh3

tjkj2002 · **Posted:** Thu Jun 04, 2009 7:21 pm

BeepBeepJeepJeep wrote:

tjkj2002 wrote:

If your throwout bearing is starting to make noise it's best to get the whole thing replaced ASAP.If that bearing freezes it can make the job alot harder and could make it alot more expensive also.

Well it started making a lot more noise today. Jeep isn't moving till I get a replacement. Should I go to Chrysler or what?

How about this: http://tinyurl.com/ordoh3

I'd skip them in the link,must not be a good place to deal with if they "don't like to ship to AZ".

Prospect62 · **Posted:** Tue Jun 09, 2009 10:34 am

Do you plan on doing the job yourself?

Clutch replacement imminent

Who is online