| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| gauge pod gauges http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=43847 |
Page 1 of 1 |
| Author: | rt_power [ Thu Jun 04, 2009 7:08 pm ] |
| Post subject: | gauge pod gauges |
i am in the process of gettin a pod and gauges for the kj. wondering where people have taped the sensors in to?? im currently looking at getting trans and water temp and am needing pointer for installing the gauges. any help would be great like this site always is 
|
|
| Author: | JL Rockies [ Thu Jun 04, 2009 7:13 pm ] |
| Post subject: | |
there's a post in the CRD tech section be GMTD that outlines where he did the do. Not sure if it translates to the gasser though. |
|
| Author: | rt_power [ Fri Jun 05, 2009 8:01 am ] |
| Post subject: | |
the water im not to worried about, im sure ill be able to find somewhere. its the trans sensor that might be the headache. im thinking of just buying a new pan and have a bung welded in to it. i have to put in an aux cooler in anyway so then would be the time to do the swap. |
|
| Author: | JJsTJ [ Fri Jun 05, 2009 11:05 am ] |
| Post subject: | |
From another thread on this subject: JJsKJ wrote: kolesy wrote: How hard is it to actually install a temp gauge for the tranny? What all is involved? I think one of the "easiest" ways is to get a manifold that installs inline w/ the hot side cooler line. There is a tap on the manifold to install a temp sensor. I think allyrand did one this way (IIRC). I saw the manifold through summitracing.com once but never tried doing the install. http://store.summitracing.com/egnsearch ... 4294845487 You can try typing the following into the search box: trans AND temp AND guage and it will bring up other posts about this topic. |
|
| Author: | Sir Sam [ Sun Jun 07, 2009 2:27 am ] |
| Post subject: | |
Personally I am just going to go with boost and EGT gauges, these are both fairly easy to tap too. |
|
| Author: | dirt pig [ Sun Jun 07, 2009 7:57 am ] |
| Post subject: | |
Haveyou considered a "Scan Guage 2" |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|