| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Driveline Howl Diagnosis? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=44874 |
Page 1 of 1 |
| Author: | Blockman [ Thu Jul 09, 2009 11:05 am ] |
| Post subject: | Driveline Howl Diagnosis? |
I am stumped with this one. I always had a slight driveline howl on my 06 CRD. The issue has magnified itself over the last little while and is most noticeable on deceleration around 30- 40 mph. No vibration or pulling associated. BTW, I just changed my u joints and all looked good a month back. Did standard side to side tests for wheel bearings and did not find anything either. I know pinion bearings can cause this type of sound. I do change fluids regularly in both front back axles for transfer case. I have approx 80,000 easy highway miles with very little loading. Looking for the expertise that only LOST provides....do not want to go to stealership. Thanks |
|
| Author: | Blockman [ Thu Jul 09, 2009 12:34 pm ] |
| Post subject: | |
Anyone?? |
|
| Author: | Sport [ Thu Jul 09, 2009 12:42 pm ] |
| Post subject: | |
what style u-joint does the liberty use in the rear? If you dont mind, I am having difficulty getting that answer. I have read that vibration could be the cv's, bearings, driveshafts. |
|
| Author: | jeepkj02 [ Thu Jul 09, 2009 1:44 pm ] |
| Post subject: | |
Sport wrote: what style u-joint does the liberty use in the rear? If you dont mind, I am having difficulty getting that answer.
1310 style Universal joints |
|
| Author: | jx2 [ Fri Aug 05, 2011 2:39 am ] |
| Post subject: | Re: |
jeepkj02 wrote: Sport wrote: what style u-joint does the liberty use in the rear? If you dont mind, I am having difficulty getting that answer. 1310 style Universal joints Not all of them, I was replacing mine yesterday and thought I'd be putt'in in 369, 1310 syle but after I bashed the hell out of the old joint to get it out I realized it was much bigger. I'm not sure but i think it's 354, 1330? Dimensions in metric is Cup - diameter 27mm, Axis diameter 92mm. Stupid me should have checked and measured before banging it out... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|