take it to the shop if your going to be running the cj like it should be run
if your going to be taking it easy and dont mind if it doesnt run like a top take care of it your self. i would personally pay the extra 180 to have the pro's do it
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Resurface Head or not ? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=45521 |
Page 1 of 1 |
| Author: | callaway [ Sun Aug 02, 2009 11:25 am ] |
| Post subject: | Resurface Head or not ? |
I pulled the head on the CJ and have a few choices as to where to go from here... The cylinder's all look good and there's nothing wrong with the block SO Should I take the head in to a shop to get resurfaced and get a valve job ( have the shop clean, re tap holes, provide gaskets, do what they need to do with valves ) for ~$300 OR Should I just clean the head myself and replace gaskets ( head, manifold, thermostat ) for approx $120. Is it worth the extra piece of mind to just take it to a shop and get it done right ? |
|
| Author: | cluelessklewer [ Sun Aug 02, 2009 11:36 am ] |
| Post subject: | |
take it to the shop if your going to be running the cj like it should be run if your going to be taking it easy and dont mind if it doesnt run like a top take care of it your self. i would personally pay the extra 180 to have the pro's do it
|
|
| Author: | JeepinJarhead03 [ Sun Aug 02, 2009 1:30 pm ] |
| Post subject: | |
def get the valve job if you don't feel comfortable doing it |
|
| Author: | tommudd [ Sun Aug 02, 2009 5:57 pm ] |
| Post subject: | |
take in it and get it done, worth it in the long run if for no other reason piece of mind 
|
|
| Author: | hrogi [ Sun Aug 02, 2009 9:12 pm ] |
| Post subject: | |
What made you take thing apart? Well if the reason has anything do with poor running or blow gaskets, get the head checked. If it passes, have it cleaned and min work done. If it fails, then do what it takes to fix it. |
|
| Author: | callaway [ Sun Aug 02, 2009 9:26 pm ] |
| Post subject: | |
hrogi wrote: What made you take thing apart?
2 cylinders ( 3 and 4 ) failed compression test - head gasket issue. Dropped the head off at a shop this afternoon - should be back by Wednesday 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|