'05 CRD Lmited:

EVIC "Miles to empty" display has always automatically reset whenever the Jeep has been refueled. However, after just filling up, it did not reset and is showing "22 miles to empty". There does not seem to be a manual reset option like changing the miles between service intervals. This is not really much of an issue, in and of itself. I'm more interested if it could be a harbinger of something more serious to come.

Fuel tank cap was tight. Tried removing and replacing with no effect.

Anybody have any ideas as to what may be going on ?

Thanks,

DOC

_________________
2005 KJ CRD Ltd Detroit TrueTrac Bilsteins G2 GDE "HOT" ECU GDE TCM "Tow Tune" "euro" TC SEGR Weeks Elbow New HG at 130K ARPs Clean CAT aFe Filter Magnaflow Exhaust EHM Cumminos In-Tank Lift Pump Hayden Fan Clutch Nylon Fan VH Enabled with GDE lower shutoff point Recalibrated Temp Gauge Tekonsha Prodigy Sears P-1 ZDDP

Are you having problems with your gas gauge?
I believe that the EVIC reads the amount of remaining fuel from the fuel tank sender unit and calculates remaining miles till empty from the calculated MPG.

The gas gauge on my 04 Libby is inaccurate and sometimes when the needle is pegged on "E" I can still drive for miles & miles. The "miles till empty" on the EVIC will then simply calculate a value of "0". I was surprised it didn't go negative

_________________
my trail & highway ride (and occasional tow rig)
04 Liberty Sport with a 2.5" lift, ProComp 245/75R16 AT's and two Hella700FF lamps (more accessories to come)

my trail queen
95 YJ with a RE 4" lift, 33" ProComp Extreme's, M8000 Winch, Lockrite Locker up front, Super35 in the rear and 4.88 gears

You could try and hit the reset button twice.
-Push once = chime
-Push button again= chime,chime
All settings should reset.

_________________
07 Cherokee/Liberty Limited 4x4
CRDStu 2.5" Lift, JBA's 4.5 UCA's
ARB Winch Bar, WARN XD9000 Winch
Light-Force 170's
3.7 Petrol / Auto
Sun Roof
Tow Pack,Scan GuageII
Reversing Camera
(pretty much stock, really)