| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Brushguard mounting help please http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=48131 |
Page 1 of 1 |
| Author: | weston02kj [ Sat Nov 28, 2009 6:00 pm ] |
| Post subject: | Brushguard mounting help please |
just got one of these for a really good deal at the junk yard but it didn't have the thing that goes from the guard through the grill. so i installed it with only the two bottom bolts but its mad flimsy. anyone have any they don't need or possibly a pic and some measurements so i could make them? Anything would help. i need to get it anchored down from that point so it doesn't flop around. Thanks, Chase |
|
| Author: | jeepskate [ Sun Nov 29, 2009 2:55 am ] |
| Post subject: | |
Not familiar with this product. There's one brace on each side, I assume? Could you maybe use some angle iron as a cheap temporary way to stiffen it up some until you get the real parts somewhere? It wouldn't look good but it wouldn't fall off either. |
|
| Author: | jeepmedic46 [ Sat Dec 05, 2009 10:43 pm ] |
| Post subject: | |
Who made the brushguard?Thinking of putting one on my jeep. 
|
|
| Author: | SavageUrge [ Wed Dec 09, 2009 8:49 pm ] |
| Post subject: | |
That's the factory brush guard that was an option from Mopar. You could contact the dealer to obtain the necessary brackets or look on eBay. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|