I received a p2314 trouble code, and found out it's most likely the ignition coil on the #5 cylinder. Now, the foolish question: Where on the engine is the #5 cylinder? Meaning, is it closest to the firewall, on the passenger side? I could just start switching the coils around, and wait until I see the code pop up again, but I thought it might be quicker to ask.

_________________
E.E.P. for my Jeep (EMPTYING EVERY POCKET)
2004 Limited - Stock no more
JcrOffroad sliders-Trail tested, mud approved
Frankenlifted
Al's A-Arms
Stock Skids
235/70/16 Cooper Discoverer HTPs

firewall
6. 5
4. 3
2. 1
front

_________________
2006 Liberty 'KJ' 4x4

Thank you! Thank you! Thank you! P2314 indicates cylinder E, which translates to cylinder 5. The problem is, I had imagined the exact opposite layout, believing that the bad coil was on the left side, near the firewall. As a result, unsurprisingly, I got the same code again, after replacing the coil. Tomorrow, it should go a little easier.

_________________
E.E.P. for my Jeep (EMPTYING EVERY POCKET)
2004 Limited - Stock no more
JcrOffroad sliders-Trail tested, mud approved
Frankenlifted
Al's A-Arms
Stock Skids
235/70/16 Cooper Discoverer HTPs