LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

My Gear Shift Came Out
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=48872		 Page 1 of 1
Author:  Landy [ Fri Jan 01, 2010 2:04 am ]
Post subject:  My Gear Shift Came Out
On my 06 Libby 6-Speed, my gear Shift handle came out again today. That's pretty neat when your going down the road and your gear shift lever just comes out. :shock:

Dealer says, "Well, you'll have to buy another one." So I showed him the cardboard holding shim tension on the lock lever that holds the steering wheel from simply moving up and down. Again he says, "You'll need to buy a new steeering column."

Ye know, I expect to replace brakes, a CV Joint, maybe a Wheel Bearing. Never have I had to replace a Gear Shift or a Steering Column.

With only 58K, I am not impressed. :furious:
Author:  InCommando [ Fri Jan 01, 2010 9:34 am ]
Post subject:  Re: My Gear Shift Came Out
Great. I have about 70K on mine and now I will start worrying about this as I pull one of my at-least-once-a-week 1-2 power shifts at about 5,000 rpm. :(
Author:  Landy [ Fri Jan 01, 2010 5:12 pm ]
Post subject:  Re: My Gear Shift Came Out
That's prolly it, I been gett'n rubber too. :-)r
Author:  JeepinJarhead03 [ Sat Jan 02, 2010 2:43 pm ]
Post subject:  Re: My Gear Shift Came Out
i havent seen the shim on the liberty for the steering column but one of the ford econolines had a similar crappy item and i was able to replace the wear item with a rolled shim like what you use on some box truck roll up doors to hold the spool on

ive never tilted the wheel in mine other than the initial adjustment when i bought it, i think if mine breaks i'll probably end up pulling it apart and figuring out how to splint and weld it in position

our manual gear shifters probably use the same plastic pin that mustangs use which is ridiculous, does hurst or b&m make anything that will work that has better hardware?
Author:  STINGN [ Sat Jan 02, 2010 2:47 pm ]
Post subject:  Re: My Gear Shift Came Out
i had the little plastic piece break on me for the plastic on the shifter, and they said I would have to replace the whole shifter jsut for a little $10 piece
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/