LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

high and low beams on at same time
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=50082		 Page 1 of 1
Author:  teckman02 [ Wed Feb 10, 2010 7:11 pm ]
Post subject:  high and low beams on at same time
has anyone tryed to mod there head light swich so you can have hi and lows on at the same time without having to hold the swich
Author:  tommudd [ Wed Feb 10, 2010 9:07 pm ]
Post subject:  Re: high and low beams on at same time
Been discussed before
bad idea!!!!!!!!
will create too much heat and burn the bulbs out,.... fast
Author:  teckman02 [ Wed Feb 10, 2010 9:14 pm ]
Post subject:  Re: high and low beams on at same time
thanks tom i tried doing a search but was not able to find anything
Author:  STINGN [ Thu Feb 11, 2010 12:28 am ]
Post subject:  Re: high and low beams on at same time
i wish it didn't :(
Author:  JL Rockies [ Thu Feb 11, 2010 10:57 am ]
Post subject:  Re: high and low beams on at same time
I would never do it because it's silly but if I were to, I would add a 2nd switch to a relay that supplied power to both the hi and low beam wires at the housing. It would be important to diode-isolate the circuit and the wires from each other so the system still works normally when used on the road (with the factory switch. All you'd need is a couple of diodes, a 30A SPDT relay, a switch, a fuse and a black belt in the 12V arts.

You kids today and your crazy ideas. :dizzy:
Author:  Cacher123 [ Fri Feb 12, 2010 6:04 pm ]
Post subject:  Re: high and low beams on at same time
This was posted on the original board. It's actually a quick project. I remember quite a few people did it but no one had any issues with heat. I'd like to hear from anyone that had this mod done long term.

See this thread:

http://www.jeepkj.com/forum/showthread.php?t=25761
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/