has anyone tryed to mod there head light swich so you can have hi and lows on at the same time without having to hold the swich

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

Been discussed before
bad idea!!!!!!!!
will create too much heat and burn the bulbs out,.... fast

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

thanks tom i tried doing a search but was not able to find anything

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

i wish it didn't

_________________
Steve
2018 RAM 1500 Rebel
2003 KJ
Mods:Exterior: Frankenlift + 2 extra rear iso, JBA UCAs, ARB Bumper w/XRC8, Safari Snorkel, 265/75/16 AT, Mopar Skids, Boulderbars, RL Gecko Sport Rack
Interior: Infinity Reference speakers, 12" Alpine Type R Sub, Alpine radio, Gauge Pods (Oil, Volts), Cobra Cb, All J Interior Rack

I would never do it because it's silly but if I were to, I would add a 2nd switch to a relay that supplied power to both the hi and low beam wires at the housing. It would be important to diode-isolate the circuit and the wires from each other so the system still works normally when used on the road (with the factory switch. All you'd need is a couple of diodes, a 30A SPDT relay, a switch, a fuse and a black belt in the 12V arts.

You kids today and your crazy ideas.

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

This was posted on the original board. It's actually a quick project. I remember quite a few people did it but no one had any issues with heat. I'd like to hear from anyone that had this mod done long term.

See this thread:

http://www.jeepkj.com/forum/showthread.php?t=25761

_________________
My pics!!
'03 Rennie w/all Tupperware
Custom Roof Basket
Mopar Tubular Brush Guard
Garmin GPS V & Laptop w/Nav software
RAM products laptop mount
Maglite w/mount
Rear cargo bay tool cabinet
AllJs Rear Shelf
Rear receiver
250k miles!
LOST #CR051230