I went to go change my transfer case fluid today and ran into a problem. The fill plug is stripped, I used PB Blaster and still can't get to grab the driver and move. The drain plug moved fine, and no I didn't drain it I just checked to see how tight that one was.

So how can I get the plug out and get a new one?

TIA

-Zack A

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA

Same thing happened to me.

If you have access to a welder, put a bolt into the stripped hole and tack it in, fallowed by turning the bolt to remove the plug

or

Get an ez out that fits the stripped area or if you have a really tight plug you will have to drill the plug and use an ez out. That is what i had to do. greese on end of the drill will hold the chips from falling into the T-case.

_________________
SOLD!!!
2005 Liberty Renegade
STT CustomSTUFF
4" Stump Lift.
JBA UCA's
245/75/16 GOODYEAR DURA TRACS


Thanks for throwing me under the bus Evil... Just remember this when you decide to turn yours back in to a... Real Jeep.