Has anyone done an install instructions/pictorial for installing UCA's?

I don't have a garage right now and it's too cold to do the install in the driveway so my wife's mechanic 1/2 brother is going to do the install fro me, but I don't want to have to be there at the time to show him how.

Any help is appreciated.

_________________
-------------------------------------------------------
http://www.cardomain.com/ride/2434197
2002 Liberty Renegade
-OME 927-Rancho RSX 17505-3 Ring Clevis-JBA UCA-Teraflex Bump Stop
-JBA-LIB25R Rear Coil-2 Upper/Lower Iso-Skyjacker H7088 Shocks-3 Hockey Puck Bump Stops
-Powerslot Rotors-Moab Rims-BFG TA/KO 265-75-R16
-ARB Bumper-Rock Rails
-Super 44 Exhaust
+ Some More Crap

Tom's comments
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?p=379416#p379416
and I think the extension was at least 15"


and JBA http://jeepinbyal.com/PDF_Files/Installation_of_A-arms_10-06-07.pdf

_________________
2005 CRD
stuff
Skeptic quod gratis asseritur, gratis negatur

_________________
2006 Sport CRD

Could the Aztecs have known, that in 2012 after a 4 year experiment, our country would cease to exist?

Not hard to do at all
left side remove battery makes it easier
front left bolt can be done with a socket and rachet alone rear you need a swivel and extensions, I have done them with extensions clear up near battery location and also done them using the rachet down near the radiator so depends. Only hard part at times doing it yourself is holding them in the right location while starting the bolts back in. Otherwise very easy I think. Well unless you have one like I had on Saturday that had lots of rust/ packed mud etc then it took 20 minutes on the drivers side

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Thanks guys. I have done it before, but my brother in law wanted to take a look at it before he could determine what was involved, and how much cash he wanted for the labor. Since he lives an hour away, I really didn't want to drive it to his house with a shot ball joint, so that he could take a look, and describing the job in detail over the phone wouldn't have been nearly as effective as sending him a pictorial.

Thanks again for pulling through for me.

_________________
-------------------------------------------------------
http://www.cardomain.com/ride/2434197
2002 Liberty Renegade
-OME 927-Rancho RSX 17505-3 Ring Clevis-JBA UCA-Teraflex Bump Stop
-JBA-LIB25R Rear Coil-2 Upper/Lower Iso-Skyjacker H7088 Shocks-3 Hockey Puck Bump Stops
-Powerslot Rotors-Moab Rims-BFG TA/KO 265-75-R16
-ARB Bumper-Rock Rails
-Super 44 Exhaust
+ Some More Crap