| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Anyone else Bend a Sway Bar? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=53508 |
Page 1 of 1 |
| Author: | RED_KJ_666 [ Sun Jun 13, 2010 4:33 pm ] |
| Post subject: | Anyone else Bend a Sway Bar? |
I just found my Sway Bar too be bent this morning. I think it probably happened when I broke the bushing off one of the links. Makes changing my JBA disconnects on/off a PITA |
|
| Author: | tommudd [ Sun Jun 13, 2010 6:11 pm ] |
| Post subject: | Re: Anyone else Bend a Sway Bar? |
How in the world did you bend it? or did you have it disconnected and not tied up? |
|
| Author: | RED_KJ_666 [ Sun Jun 13, 2010 6:17 pm ] |
| Post subject: | Re: Anyone else Bend a Sway Bar? |
I broke a Sway Bar Link bushing off. Crossed a Rutt hard and started up a huge hill with a switchback so I couldn't stop too see what was broken without getting stuck so I ran up the hill with the sway bar smashing the entire time. I always noticed my JBA pieces where a little hard to connect on the passenger side then this morning I had some time and completley took the Sway Bar off to inspect it and put on some Daystar Poly bushings. That's when I noticed that the little ear where the bushing should bolt to is bent towards the engine bay and the driver side is not. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|