Ok got a question. I replaced my broken multifunction switch about 10 mins ago. I don't have fog lights but the switch that was sent was the fog light version. When I pull the switch I can hear a relay activate and the fog light dash light comes on. I also noticed a while back that I have wiring all the way to the grill for fog lights. My question is could I technically hook up my hella's to the fog light wiring and use the multifunction switch to cut them on?

Right now they are ran threw a switch box for my warning lights (FD/EMS). and it have it wear it turns on the overhead light bar dash light however I plan on adding some lights up top at some point.

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA

i am 99 % sure check i would try using this as a guide http://moparestore.trademotion.com/moparimages/accessory%20catalog/images/isheets/K6859493.pdf

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

THANKS I'll check for the relay tomorrow. Like I said I know the wiring is there b.c their are two plugs where the fog lights would be behind my grill. Plus when I pull the switch I hear the relay clicking

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA

Finally got around to checking for the fuse and relay. Everything is there, so I guess since everything is installed all the way to the lights, Ill put my hella's on my fog light switch. Thanks for the help teckman

_________________
Zack A.
2005 Rocky Mountain Ed.
W4ZWA