LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

error code leads to new plug
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=55884
Page 1 of 1

Author:  W9JAB [ Mon Sep 27, 2010 2:47 pm ]
Post subject:  error code leads to new plug

I got a check engine light on my Jeep. It showed a miss-fire on a cylinder.
The newer type motor has a coil on each plug. So after replacing the coil,
The error code cleared, But while I was there I pulled the plug to take a look,
the gap looked way too big, so I closed it a little, put in back in, and headed off
to the auto parts store.
Now I do know that this is not a 100k motor between tune ups, the book say's
change plugs every 30k.
Looking at the auto parts store at all the "flavors" of plugs from $1.50 -$7+
I was a bit overwhelmed, I put in them split fires in an different motor but did
not see any big deal in them from standard plugs.
Well I thought I'd try the Bosch +4 platinum plugs, I was sold with "if you do not
notice a difference your money back"
The short story is WOW big difference, smother idle, at lower RPM's, better acceleration,
smother shifting. Can't wait to check on mileage. :pepper: :BANANA: :pepper:

Author:  STINGN [ Mon Sep 27, 2010 2:54 pm ]
Post subject:  Re: error code leads to new plug

NICE!...btw, did i see you on 22 and bg road the other day by dominicks?

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/