Does anyone have experience that
the zerts on my JBA A-arm 4.5 seems to be clog.
I'm unable to get the grease in it ,it just flow on every side...??
Is there any way to clean it ,any type of degreaser that won't dammage
anything inside.
thanks

_________________
Libby 2004
Modified.

Try a paper clip or small wire to clear the port.

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.

yep works every time

and i know it sounds backwards, but on my tractors i keep some grease on them so trash dont get near the zert, just wipe it off and put fresh grease into it, then just a little to cover it back up

_________________
2002 KJ Limited 3.7, 5.25" lift via coilovers, custom HD rear springs, 32.2" tires on moabs (soon 33s) 4.56/JBA diff, OX lockers front/rear, NP241OR, Parker Fab front/rear bumpers, rock rails and roof rack, Viair OBA.

2006 KJ sport 3.7, 4" Ironman lift, 32" tires, Parker Fab front/rear bumpers and rock rails.

I use rubber brake bleeder covers to keep my zerks clean. They're available in a variety of sizes.

_________________
'04 Sport, 3.7, NV3550, NP231, OME and 215/85's
no ABS/TCS/ESP/CIA/FBI/DEA/UFO/MYOFB...

me too