| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Intermidiate shaft seal http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=56664 |
Page 1 of 1 |
| Author: | adamkrz [ Wed Nov 03, 2010 6:03 pm ] |
| Post subject: | Intermidiate shaft seal |
Anyone replace one yet? I just replaced mine when I replaced my intermidiate shaft and darn it was a bear to remove, took about 2 hours of prying due to the rust buildup and rtv stuck in there. Also I used a rebuild CV halfshaft from napa and it seems that the inner boot has too many folds in it with a possible wear area where the boot folds over the rather large clamp head. |
|
| Author: | Jeepjeepster [ Thu Nov 04, 2010 11:39 am ] |
| Post subject: | Re: Intermidiate shaft seal |
About the folding over of the cv boot, check out my thread from when I replaced my cv with a napa reman'd. The boot had some pressure in it, after releaving it the cv boot went back to normal. http://www.jeepkj.com/forum/showthread.php?t=44892 |
|
| Author: | adamkrz [ Thu Nov 04, 2010 3:56 pm ] |
| Post subject: | Re: Intermidiate shaft seal |
Thanks for the heads up- Great write-up on your shaft replacement, I'LL try and do what you did to relieve the pressure. I was able to separate the cv from the shaft with some moderate hammering,It wasn't to bad in there just enough to cause a little play, I had a slight thumping noise like you had only when off the gas. Thanks again.. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|