LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Bumper trimming
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=5758		 Page 1 of 1
Author:  KJ Willy [ Sat Feb 11, 2006 6:56 pm ]
Post subject:  Bumper trimming
Ok we have seen the 02-04 trim bumpers, what about any 05's?

The red is an idea but I am very squemish about trying to cut up a piece so big, so has anyone else done something like this?

Image

Thanks
Author:  JJsTJ [ Sat Feb 11, 2006 8:24 pm ]
Post subject: 
Chop off everything below the green lines. :shock:
Image

Go for it!! :twisted:
Author:  Blue KJ in PA [ Sat Feb 11, 2006 8:34 pm ]
Post subject: 
I like the green line...going to trim my 03 on of these days soon when I pull it for the front hitch install.
Author:  USAFCOP [ Sat Feb 11, 2006 9:22 pm ]
Post subject: 
Image

First thing to cut off is that chrome and black thing in the middle! :-)r

Seriously, make sure you look at how and where it is connected before trimming. If you cut too much, then you will have a saggy cover.
Author:  Steakgoddess [ Sat Feb 11, 2006 9:37 pm ]
Post subject: 
JJsKJ wrote:
Chop off everything below the green lines. :shock:
Image

Go for it!! :twisted:


What he said. :wink:
Author:  jpzkj [ Sat Feb 11, 2006 10:30 pm ]
Post subject: 
Steakgoddess wrote:
JJsKJ wrote:
Chop off everything below the green lines. :shock:
Image

Go for it!! :twisted:


What he said. :wink:



Yep....x's 3
Author:  Metrowest_Kev [ Sun Feb 12, 2006 2:20 am ]
Post subject: 
Mean! Do it! Chrome rocks!
Author:  Guest [ Sun Feb 12, 2006 6:10 am ]
Post subject: 
Image

I think that looks much better than any of the aforementioned suggestions:)
Author:  JJsTJ [ Sun Feb 12, 2006 9:58 am ]
Post subject: 
Hmmmm...... It needed a little something more.
Image

It is Begging for it too! :twisted:
Author:  KJ Willy [ Sun Feb 12, 2006 1:23 pm ]
Post subject: 
Ya the Glass Raider plate will disappear unfortunatly here in a couple of weeks when I put my NV plates on.

I have tow hooks which should be here this week to go on next weekend, I think that I will start with the red cut first to see how it goes and may(big MAY) go for the green, but that will take on a lot of extra stuff.

So no one else with an 05 has done any bumper trimming??

Also what is the best tool to use to cut it to get the smoothest, straightest cut?

Thanks for all the input.
Author:  Calvin56 [ Sun Feb 12, 2006 1:41 pm ]
Post subject: 
Use the finest blade you can, and have your line clearly marked. You could try and file down some of the rough pieces, but putting door edge trim around the cuts really smooths things out nicely.
Author:  Myke [ Sun Feb 12, 2006 4:45 pm ]
Post subject: 
JJsKJ wrote:
Hmmmm...... It needed a little something more.
Image

It is Begging for it too! :twisted:


Hahaha I say do it I was gonna do mine but I think I might be selling it for a newer year.
Author:  chemguy [ Sun Feb 12, 2006 8:26 pm ]
Post subject: 
Just ta\ke the whole thing off and weld a railroad tie wrapped in barbed wire and some spikes on :D there to keep with the Raider theme.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/