| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Replacing ABS wires - How hard? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=57588 |
Page 1 of 1 |
| Author: | Boostedxt [ Thu Dec 16, 2010 5:42 pm ] |
| Post subject: | Replacing ABS wires - How hard? |
Hey everyone. I have been showing my abs,bas, and TC lights for the past little bit and now wanna fix it. I stopped by my local dealership and picked up the replacement kit from Jeep. $39 as they are no longer just selling the wires and you have to buy the sensor with it.  Who has done this before? how hard is it? pictures? advice?thanks joe |
|
| Author: | JeepMorrison [ Thu Dec 16, 2010 5:55 pm ] |
| Post subject: | Re: Replacing ABS wires - How hard? |
maybe just make your own wireharness???? i dont know if they are calibrated to the wires too, might just spend the 40 bucks....is it just one wheel? |
|
| Author: | Boostedxt [ Thu Dec 16, 2010 6:39 pm ] |
| Post subject: | Re: Replacing ABS wires - How hard? |
4x4kayak2112 wrote: maybe just make your own wireharness???? i dont know if they are calibrated to the wires too, might just spend the 40 bucks....is it just one wheel? yeah. its the front left wire thats torn. its pretty common as the wires are pretty crappy. joe |
|
| Author: | JeepMorrison [ Thu Dec 16, 2010 10:04 pm ] |
| Post subject: | Re: Replacing ABS wires - How hard? |
yea, just make the harness, and if it works, then hey cool, if not then, just buy the harness/sensor. |
|
| Author: | vintageroy13 [ Fri Dec 17, 2010 12:40 am ] |
| Post subject: | Re: Replacing ABS wires - How hard? |
it is actually super easy. i snapped one of my sensors off when i was doing the lift. you literally take out one screw, pry the sensor out and take off the wire, then you reinstall the new one---pretty straight forward if you are somewhat mechanically inclined. it took about 15 minutes. good luck |
|
| Author: | Boostedxt [ Fri Dec 17, 2010 2:03 pm ] |
| Post subject: | Re: Replacing ABS wires - How hard? |
I got the new kit. very straight forward, however on the 2007 model it looks like I need to remove the caliper and rotor to get to the sensor plug. oh well...time to get working..  joe |
|
| Author: | Boostedxt [ Fri Dec 17, 2010 3:59 pm ] |
| Post subject: | Re: Replacing ABS wires - How hard? |
Done and fixed...I wrote up a how to in the tech section joe |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|