Hey everyone. I have been showing my abs,bas, and TC lights for the past little bit and now wanna fix it. I stopped by my local dealership and picked up the replacement kit from Jeep. $39 as they are no longer just selling the wires and you have to buy the sensor with it. Who has done this before? how hard is it? pictures? advice?

thanks

joe

maybe just make your own wireharness???? i dont know if they are calibrated to the wires too, might just spend the 40 bucks....is it just one wheel?

_________________
2002 KJ Limited 3.7, 5.25" lift via coilovers, custom HD rear springs, 32.2" tires on moabs (soon 33s) 4.56/JBA diff, OX lockers front/rear, NP241OR, Parker Fab front/rear bumpers, rock rails and roof rack, Viair OBA.

2006 KJ sport 3.7, 4" Ironman lift, 32" tires, Parker Fab front/rear bumpers and rock rails.

yeah. its the front left wire thats torn. its pretty common as the wires are pretty crappy.

joe

yea, just make the harness, and if it works, then hey cool, if not then, just buy the harness/sensor.

_________________
2002 KJ Limited 3.7, 5.25" lift via coilovers, custom HD rear springs, 32.2" tires on moabs (soon 33s) 4.56/JBA diff, OX lockers front/rear, NP241OR, Parker Fab front/rear bumpers, rock rails and roof rack, Viair OBA.

2006 KJ sport 3.7, 4" Ironman lift, 32" tires, Parker Fab front/rear bumpers and rock rails.

it is actually super easy. i snapped one of my sensors off when i was doing the lift. you literally take out one screw, pry the sensor out and take off the wire, then you reinstall the new one---pretty straight forward if you are somewhat mechanically inclined. it took about 15 minutes. good luck

_________________
2006 liberty 65th edition
Sylvania Silver Star Ultra II headlights
K&N FIPKII intake
Sony headunit with I-pod hookup
OME/Rancho lift
Kumho Road Venture AT's 245/75 16's
OEM front skid
Jet Chip stage 1
on the list:
custom exhaust
the rest of the skids
roof rack
lights
and the list goes on

I got the new kit. very straight forward, however on the 2007 model it looks like I need to remove the caliper and rotor to get to the sensor plug.

oh well...time to get working..

joe

Done and fixed...I wrote up a how to in the tech section

joe