| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rear driveshaft U-joints removal ??? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=58932 |
Page 1 of 1 |
| Author: | Liberty02sport [ Wed Feb 16, 2011 12:39 am ] |
| Post subject: | Rear driveshaft U-joints removal ??? |
Tried searching but didn't come up with the info. I was after....I'm replacing the rear U-joints on my '02 and am wondering if it's possible to get the front U-joint up by the trafer case out without pulling the slip yoke ?? Are the u-joints pressed in as in you need a shop press to get them out ?? I've been trying with a large "C" clamp to get the cups to press out but I'm not having any luck... Any ideas ?? Thanks.. |
|
| Author: | tommudd [ Wed Feb 16, 2011 8:15 am ] |
| Post subject: | Re: Rear driveshaft U-joints removal ??? |
just unbolt the drive shaft, clip the clip that holds the rubber boot in place and pull it out. replace the u-joints the way you do any of them and replace . You can use a wire tie in the rubber boot to seal it now. Takes a little more than a C clip or has on mine and the ones I have done so far on the KJs I just use the vice and a BFH  Done!! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|