| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| multi-function switch or hazard switch http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=59935 |
Page 1 of 1 |
| Author: | arengant [ Mon Apr 04, 2011 10:08 pm ] |
| Post subject: | multi-function switch or hazard switch |
I was driving today in the rain (as usual here) with head/fog lights on. Turning left with signal, and then it just stopped flashing. The whole trip home I couldn't get the left signal to work again (no flashing noise, no illumination on dash, no illumination of actual bulb outside) but the right side works fine. When I tried my hazards, ONLY the right side illuminated (dash/outside). By the time I got home the signal was working again out of no where.... After looking on here, I narrowed it down to the multi-function switch, or hazard switch. Neither are as cheap as the traditional blinker switch, so if anyone has experience this and knows for sure that would save me 50 bucks |
|
| Author: | irollgen4s [ Mon Apr 04, 2011 10:12 pm ] |
| Post subject: | Re: multi-function switch or hazard switch |
Ever think that the bulb is just bad....? Most cars blink really fast, or stop blinking entirely.. unless you mean the switch doesnt activate anything at all. |
|
| Author: | arengant [ Tue Apr 05, 2011 11:06 pm ] |
| Post subject: | Re: multi-function switch or hazard switch |
I recently replaced the rear, but because the other side does NOT blink faster, I thought it wouldn't be the bulb. Won't be too hard to check the front though. I am leaning towards the Hazard. The multi-function just sends a signal to the flasher (Hazard), either left or rigth. However, when I try just engaging the Hazards, ONLY the right side illuminates, on the dash and out side markers. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|