LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Replacing HP steering hose, need to know O ring size
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=60147		 Page 1 of 1
Author:  BjBnet [ Thu Apr 14, 2011 3:02 pm ]
Post subject:  Replacing HP steering hose, need to know O ring size
Long story short, I bought a set of new Edelmann HP steering hoses and it came with everything but the O rings which states they are included. The parts store say they don't know the size and have no more of those kits (80477) in stock to check but they said they will get me some O rings if I could get the size and type of material they are made of.
I tried calling Edelmann but that's a waste of time...menu after menu and then "please leave a message"

Anyway, does anyone here know what size O rings that go on the end of the fittings?
Thanks!
Author:  ridenby [ Thu Apr 14, 2011 6:39 pm ]
Post subject:  Re: Replacing HP steering hose, need to know O ring size
Could not find size listed in FSM. When I did mine just used a little green one,kind of a square profile to it. I know this isn't much help.
Author:  tjkj2002 [ Thu Apr 14, 2011 10:36 pm ]
Post subject:  Re: Replacing HP steering hose, need to know O ring size
BjBnet wrote:
Long story short, I bought a set of new Edelmann HP steering hoses and it came with everything but the O rings which states they are included. The parts store say they don't know the size and have no more of those kits (80477) in stock to check but they said they will get me some O rings if I could get the size and type of material they are made of.
I tried calling Edelmann but that's a waste of time...menu after menu and then "please leave a message"

Anyway, does anyone here know what size O rings that go on the end of the fittings?
Thanks!

Have them order another hose and make sure the o-rings come with it.It's not a oridinary o-ring and you can not use a rubber o-ring either as it will be eaten away by the ATF+4.
Author:  BjBnet [ Fri Apr 15, 2011 7:35 am ]
Post subject:  Re: Replacing HP steering hose, need to know O ring size
tjkj2002 wrote:
BjBnet wrote:
Long story short, I bought a set of new Edelmann HP steering hoses and it came with everything but the O rings which states they are included. The parts store say they don't know the size and have no more of those kits (80477) in stock to check but they said they will get me some O rings if I could get the size and type of material they are made of.
I tried calling Edelmann but that's a waste of time...menu after menu and then "please leave a message"

Anyway, does anyone here know what size O rings that go on the end of the fittings?
Thanks!

Have them order another hose and make sure the o-rings come with it.It's not a oridinary o-ring and you can not use a rubber o-ring either as it will be eaten away by the ATF+4.

Ya that's what the guy was concerned about. He wasn't sure about the tranny oil being safe or not. Thanks again Troy
Author:  BjBnet [ Sat Apr 16, 2011 7:24 am ]
Post subject:  Re: Replacing HP steering hose, need to know O ring size
never mind, dealer has them.... 5 bucks each :dizzy:
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/