What’s the part # for the Fumoto Oil Drain Valve that fit’s the gasoline KJ?
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Fumoto Oil Drain Valve http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=62372 |
Page 1 of 1 |
| Author: | dieselenthusiast [ Thu Sep 01, 2011 12:07 am ] |
| Post subject: | Fumoto Oil Drain Valve |
What’s the part # for the Fumoto Oil Drain Valve that fit’s the gasoline KJ?
|
|
| Author: | JeepinJarhead03 [ Thu Sep 01, 2011 12:56 am ] |
| Post subject: | Re: Fumoto Oil Drain Valve |
F106 i do believe if that doesn't look right check F101 pretty confident it's one of those 2 with more than 50% of the certainty going to F106 |
|
| Author: | dieselenthusiast [ Thu Sep 01, 2011 1:11 am ] |
| Post subject: | Re: Fumoto Oil Drain Valve |
JeepinJarhead03 wrote: F106 i do believe if that doesn't look right check F101 pretty confident it's one of those 2 with more than 50% of the certainty going to F106 
|
|
| Author: | boilermaker2 [ Mon Oct 17, 2011 12:03 pm ] |
| Post subject: | Re: Fumoto Oil Drain Valve |
Please reply whether it is the F106 or F101. Does it stick out too far (or threads are wrong) to use one one on the front axle? I noticed that both plugs use the same size hex-socket. Has anyone done this or is there not enough room between the axle and skid plate> Boilermaker2 |
|
| Author: | dieselenthusiast [ Mon Oct 17, 2011 8:16 pm ] |
| Post subject: | Re: Fumoto Oil Drain Valve |
boilermaker2 wrote: Please reply whether it is the F106 or F101. Does it stick out too far (or threads are wrong) to use one one on the front axle? I noticed that both plugs use the same size hex-socket. Has anyone done this or is there not enough room between the axle and skid plate> Boilermaker2 The 3.7L engine drain plug is the F106, but I haven't installed it yet. I'm waiting for my next oil change. Are you wanting to put one on your front diff? |
|
| Author: | boilermaker2 [ Wed Oct 19, 2011 10:51 am ] |
| Post subject: | Re: Fumoto Oil Drain Valve |
I would like to put one on BOTH the oil pan and the front axle/diff. The question is which F# (part numbner) will work for the oil pan and the front axle and whether the front axle fumoto is a viable option due to clearance issues with skid plate and engine blanket. For $30/piece it is simple piece of mind. B2 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|