LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

All J Rack installation on an 05?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=64021		 Page 1 of 1
Author:  arengant [ Tue Dec 06, 2011 1:34 pm ]
Post subject:  All J Rack installation on an 05?
I am about to install my All J rack, but the pictures in the directions do not match up to my jeep. I am assuming the plastic in the rear has been redesigned for 05-07. Does anyone have pictures of their rack installed on 05?

I saw one in person a year ago, and it looked like a chunk of plastic had to be cut out, not just a hole drilled.

Thanks!
Author:  TheBartlett [ Tue Dec 06, 2011 9:27 pm ]
Post subject:  Re: All J Rack installation on an 05?
I had the same issue when I installed it. I ended up mounting the brackets to the seat backs first and bolted the rack to those brackets. Then using a level and scissor jack I go the hole rack level front to back and side to side. I then mounted the back brackets and pilot drilled the hole locations. Then I was able to remove the rack, install the threaded inserts behind the interior and bolt everything in place. Worked out well and was not very difficult. Hope this helps.

Image
Image
Image
Image
Author:  arengant [ Tue Dec 06, 2011 11:04 pm ]
Post subject:  Re: All J Rack installation on an 05?
Thanks a lot!

Did you need a spacer between the plastic and the actual body where the nutzert is?
Author:  TheBartlett [ Wed Dec 07, 2011 1:12 pm ]
Post subject:  Re: All J Rack installation on an 05?
No sir, I did not use a spacer at all, I just had the nutzert installed far enough into the sheet metal so that it did not push out on the interior.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/