I INSTALLED A rear tow hook inan 05 rocky mountain
is it held in by only 2 bolts? are there supposed to benuts or just the bolts?
also can someone send me a picture of tjere tow hook up close so i can see how the position of the hook is onto the frame and the bolts into the frame of the car.
thanks
bryan

_________________
2005 Rocky Mountain Edition
silverstars, 4d maglite, foglights on front bumper, mudflaps, rear hitch, front tow hooks,rocky mountain hood decals, heavy duty tranny cooler
in progress/planning:2.5"lift, armor

I thought it was three bolts, one shared with the gas tank skid...

I'm going to be removing my tow hook to install a rear receiver later this week probably, so I'll take a look if nobody gets back to you.

_________________
Jeff 2005 Jeep Liberty Renegade
4x4, 6spd, Leather, Sunroof, trak-loc, skids/rails, hitch+shackle, hooks, Alpine/iPod, Thule, GPS, CB, Frankenlifted w/ 31" MTRs
Photos Cardomain

I HAVE A 3rd hole and a 3rd bolt
but the third hole isnt threaded and is too big for the bolt

_________________
2005 Rocky Mountain Edition
silverstars, 4d maglite, foglights on front bumper, mudflaps, rear hitch, front tow hooks,rocky mountain hood decals, heavy duty tranny cooler
in progress/planning:2.5"lift, armor

aha, that must be the case of the Nutzert thingy. I've only heard of these in legend (or probably more likely by reading posts on here)

There some kind of nut that attaches to the frame in that hole that you bolt into. Not sure if it's called "nutzert" or if it's the M-bolt that was mentioned before. I'll do a little searching and see if it rings any bells.

_________________
Jeff 2005 Jeep Liberty Renegade
4x4, 6spd, Leather, Sunroof, trak-loc, skids/rails, hitch+shackle, hooks, Alpine/iPod, Thule, GPS, CB, Frankenlifted w/ 31" MTRs
Photos Cardomain