I know I have seen this on here before but search didn't give me any results. I am in the process of removing everything on my jeep for line-x. How do I get those rocker trim pieces off without damaging them?
Thanks
Sam

Gently pry one end up just enough to get a knife in there to cut the trim tape. Alternate between cutting and gradually pulling up on the trim. Just take it slow and should be able to get them off no problem

_________________
02 LIberty Renegade
OME/Bilstein
JBA Gen4.5
IRO 3 Linked
245/75 Duratracs

when i took them off, i just ripped them off and broke the little plastic connectors, bought another couple boxes of connectors for the install. much less hassel

_________________
06 CRD limited
Frankenlift, JBA 1/4 top plate, 3 clevis rings, 3 stacked iso's
JBA UCA and quick disconnects
Procomp rockkrawlr 16x8 4.25bs with 265-70-65 General Grabber AT2's
Mopar full skid plates, JCR stage 3 Rock Rails
Kenwood HU, 6.5 pioneer marine grade door speakers, JL stealthbox kenwood amp
GDE HOT tune
Soon to come
RL Rock monitor bumper

Thanks for the responses. Wasn't sure how they were held on there.