| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Getting wires...Inside? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=7299 |
Page 1 of 1 |
| Author: | Jeepjeepster [ Mon Apr 03, 2006 2:45 pm ] |
| Post subject: | Getting wires...Inside? |
How do you all go about running wires inside the jeep? I have an xm antenna and a cb antenna on top and had it running along the weather striping and into the front drivers where I crossed behind the weather stripping right where the door hinges. My floor has now been flooded twice and Im getting tired of it, so I took all them off today until I find a better way to run them. Thanks, pics are good too! 
|
|
| Author: | Jinxman [ Mon Apr 03, 2006 3:30 pm ] |
| Post subject: | |
Third Brake light... 2 screws out and you have easy access into the cab...then just pop the plastic molding that holds the roof liner in the back...then you can easily run the wire along the carpet inside the molding.... Just be sure to put the brake light back on snugly...I don't know of anyone who has done it this way and not had any leaks. At least that is the best way to run the small satellite radio antenna, I don't know about CB antenna wire. That is a little thicker and might give you problems unless you do a little modification. |
|
| Author: | Jeepjeepster [ Mon Apr 03, 2006 5:04 pm ] |
| Post subject: | |
Idk if my wire is long enough with my xm, Ill try it though. My cb had the perfect lengh, so I do not have to make choices there. |
|
| Author: | raceinfan [ Mon Apr 03, 2006 5:12 pm ] |
| Post subject: | |
my XM antenna goes thru the 3rd brake light also but I didn't do the work |
|
| Author: | 4wdParakeet [ Mon Apr 03, 2006 8:21 pm ] |
| Post subject: | |
I don't know about xm antenna but my CB antenna is ran through the side panels on the drivers side and exited out the bottom of the boot for the swinggate wiring harness. Works great for my needs. Parakeet |
|
| Author: | KJFROG [ Wed Apr 05, 2006 3:11 pm ] |
| Post subject: | |
Third brake light works, but use a extra piece of foam tape so you dont have any leaks |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|