my local autozone guy said just glue it back on... but won't the heat burn thru the glue
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Back Window Heater Lead http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=74130 |
Page 1 of 1 |
| Author: | riptricket [ Wed Feb 13, 2013 12:01 am ] |
| Post subject: | Back Window Heater Lead |
Back Window Heater Lead... it broke when trying to heat my back window after our snow storm here. Anyone know how to solder it back on if it can be? |
|
| Author: | John3:17 [ Wed Feb 13, 2013 11:36 am ] |
| Post subject: | Re: Back Window Heater Lead |
Silver conductive epoxy http://www.frostfighter.com/prt2000.htm |
|
| Author: | riptricket [ Wed Feb 13, 2013 11:40 am ] |
| Post subject: | Re: Back Window Heater Lead |
my local autozone guy said just glue it back on... but won't the heat burn thru the glue
|
|
| Author: | SavageUrge [ Thu Feb 14, 2013 1:46 pm ] |
| Post subject: | Re: Back Window Heater Lead |
I don't think it gets hot enough to burn through the glue. I used the Frost Fighter kit last year - make sure you wait for a nice warm day above 65 degrees. I followed all the directions and it works all last winter, but this year the defroster isn't working again. I keep forgetting to look at it, but I've read that those kits don't last for sh*t...apparently that's true. |
|
| Author: | riptricket [ Thu Feb 14, 2013 4:09 pm ] |
| Post subject: | Re: Back Window Heater Lead |
i am going to try some jb weld. |
|
| Author: | John3:17 [ Thu Feb 14, 2013 5:02 pm ] |
| Post subject: | Re: Back Window Heater Lead |
And how does the power pass through that? http://www.mgchemicals.com/products/adh ... poxy-8331/ |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|