LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

moab 16x8 5 inch backspace bolt right up?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=79162		 Page 1 of 1
Author:  crippled [ Fri May 23, 2014 12:58 am ]
Post subject:  moab 16x8 5 inch backspace bolt right up?
just want to make sure they bolt right up, no jba UCA rubbing? they are an inch wider with littlw difference on backspacing. I do not wanna waste my time if I need spacers for them or something.
Author:  TIJKK1220 [ Fri May 23, 2014 4:02 am ]
Post subject:  Re: moab 16x8 5 inch backspace bolt right up?
They bolt up like they were made for it. No rubbing issues :). I want them so bad lol!

Sent from my HTC One using Tapatalk
Author:  tommudd [ Fri May 23, 2014 8:35 am ]
Post subject:  Re: moab 16x8 5 inch backspace bolt right up?
As long as they are from a TJ Wrnagler and not a JK you're good
Only issue is tire size and 8 inch wide wheel
Author:  crippled [ Fri May 23, 2014 2:13 pm ]
Post subject:  Re: moab 16x8 5 inch backspace bolt right up?
tommudd wrote:
As long as they are from a TJ Wrnagler and not a JK you're good
Only issue is tire size and 8 inch wide wheel


Ok just had me worried since my 245 are already just a finger gap away from the jba uca. I though the moab being wider will make it contact. I assume if it won't contact the uca it will be darn close.
Author:  tommudd [ Fri May 23, 2014 2:30 pm ]
Post subject:  Re: moab 16x8 5 inch backspace bolt right up?
The rear flange of the wheel will be about the same as running a stock wheel, due to the width of the wheel the center of the tread will be moved out 1/2 inch or so so it should give you more room. The tread of the 245-75s not being as wide as the wheel, so the sidewalls will be sloping in giving more room in a way
Author:  crippled [ Fri May 23, 2014 11:41 pm ]
Post subject:  Re: moab 16x8 5 inch backspace bolt right up?
Gotcha thanks for explaining that to me. These are the quadratic replica wheels. 5 inch bs and 16x8. 5x4.5
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/