| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| KJ Front Wheel Bearing - Recomendation http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=79322 |
Page 1 of 1 |
| Author: | Pippobug [ Wed Jun 11, 2014 5:16 am ] |
| Post subject: | KJ Front Wheel Bearing - Recomendation |
Hi, Well I am now rapidily coming up to have to replace my driver side (for you in US passenger side, KJ is RHD) front bearing again. Up to now I have swapped them out about 20K mls back with orignal Mopar ones. I am now looking for something that will last a bit longer, any recomendation? Timken (?!) any good? Fil. |
|
| Author: | bugnout [ Wed Jun 11, 2014 1:33 pm ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
I have the Timken unit bearings on both side. Replaced the originals in 2010. I think I have about 40k miles on them So far so good. |
|
| Author: | Pippobug [ Wed Jun 11, 2014 4:58 pm ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
Thank you, any chance of a link where I can find them? I need with ABS connection. |
|
| Author: | Leeann [ Wed Jun 11, 2014 8:47 pm ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
www.rockauto.com They ship worldwide. That's where I got mine, though I don't have ABS. |
|
| Author: | Pippobug [ Thu Jun 12, 2014 11:52 am ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
I tried to have a look and can't work out the correct part. I am sure they must have them with the ABS sensors inside. I thought all KJ even in the US would come with ABS as standard as a minimum. |
|
| Author: | bugnout [ Thu Jun 12, 2014 2:33 pm ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
Didn't see them on rockauto either. a quick search found them at http://www.1aauto.com/jeep-liberty-wheel-bearing-and-hub-assembly-front-timken-ha599455l/i/tkshf00151?f=557082&y=2003&utm_campaign=gb_csv_br&utm_content=SHF&gclid=CjgKEAjwn-WcBRD61NHM-uqDrm4SJADrP4tP9HAxjElMPaTmRCS8g-M3jd6zcIGYze0r3l94B5VQrvD_BwE Probably cheaper places, but this should get you a part number to search on. |
|
| Author: | tjkj2002 [ Thu Jun 12, 2014 2:38 pm ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
Pippobug wrote: I tried to have a look and can't work out the correct part. I am sure they must have them with the ABS sensors inside. I thought all KJ even in the US would come with ABS as standard as a minimum. All KJ's from '02-'07 use the same front unit bearings,2wd or 4wd.The only difference is ABS or not and ABS did not become standard till '06 when ESP became standard. You can use ABS unit bearings if need be,just cut the wires off the sensor but leave the sensor bolted in place to keep junk out of the bearing. Besides OEM I'd trust SKF or Timkin bearings before any other brand but Timkin is going down hill since they started using china made stuff in some of the bearings.Most SKF stuff uses German or Japan made bearings which are high quality. |
|
| Author: | bugnout [ Thu Jun 12, 2014 2:41 pm ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
tjkj2002 wrote: Pippobug wrote: I tried to have a look and can't work out the correct part. I am sure they must have them with the ABS sensors inside. I thought all KJ even in the US would come with ABS as standard as a minimum. All KJ's from '02-'07 use the same front unit bearings,2wd or 4wd.The only difference is ABS or not and ABS did not become standard till '06 when ESP became standard. You can use ABS unit bearings if need be,just cut the wires off the sensor but leave the sensor bolted in place to keep junk out of the bearing. Besides OEM I'd trust SKF or Timkin bearings before any other brand but Timkin is going down hill since they started using china made stuff in some of the bearings.Most SKF stuff uses German or Japan made bearings which are high quality. In the North America, 05 CRD's have front ABS without TCS |
|
| Author: | tjkj2002 [ Thu Jun 12, 2014 2:57 pm ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
bugnout wrote: In the North America, 05 CRD's have front ABS without TCS '02 through '05's either have 3 channel ABS or no ABS.There is no "front wheel ABS" ,also known as 2 channel ABS,in any KJ.Your right no '02-'05 KJ has traction control,that did not appear till '06+ when they went to a 4 channel ABS system for ESP. ABS was a option till '06 but CRD's(North American) may have had it by default due to the engine option selected. |
|
| Author: | Pippobug [ Fri Jun 13, 2014 7:37 am ] |
| Post subject: | Re: KJ Front Wheel Bearing - Recomendation |
Hi Thank you for your help. One last question, I have been told that Crown front bearing are also very good and that have the same components as Timken ones, is that true? I can get them over here more easily but they are pricy. Fil |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|