I was replacing my driver's seat cover last weekend. Got the seat out and cover on without a huge amount of trouble....then I went to put the seat back in. I got two seat hold down bolts and the left rear hold down nut on fine, but when I went to put in the front right bolt, about half way in, the nut under the floor broke loose. Now all the bolt does is spin. I cant get it out or tighten it and I can't get to the nut inside the floor. And the seat flexes back under acceleration....... Any ideas as to fix this situation?

Thanks for any help.

_________________
2005 KJ
1996 XJ (died at 337,000 miles)
....and still crazy after all these years.

Drill it out. all the way through the body. use grade 5 or 8 or above bolts. seal that bolt up under the body.

_________________
2012 Jeep Liberty KK 109k miles and stong
4" lift.
Gen 5.5 A-Arms
Maxxis 31x10.50x15
ATS42rle -> Jasper for the long-term win!