How did you guys wire your lightbar on your roof? Kinda unsure how to make it as less noticeable and clean as possible. Thanks in advance!

_________________
2011 Brilliant Black KK Sport - 3" OME/Bilstein & JBA UCA's, 245/75r16's & other goodies

some where on here NAM did a post on his install. though its not a light bar, but the wiring is exactly the same.

_________________
2012 Jeep Liberty KK 109k miles and stong
4" lift.
Gen 5.5 A-Arms
Maxxis 31x10.50x15
ATS42rle -> Jasper for the long-term win!

Ran the wires inside the square tubing, except for the 'pigtail' that enters the roof rail clamshell.



... down the 'B' pillar, under the door jamb, and to the homemade fuse panel and junction box...

_________________
Brad
International Man of Mystery, Singer of Sentimental Ballads,
Soldier of Fortune, Guardian of the Holy Hand Grenade of Antioch,
Bass Player Extraordinaire, Keeper of the Eternal Flame
of the Immortals, Master Swordsman, The "5th" Beatle,
Expert Marksman, Stand-up Comedian, Martial Artist,
Jeep owner, and all around swell guy.

Thanks guys

_________________
2011 Brilliant Black KK Sport - 3" OME/Bilstein & JBA UCA's, 245/75r16's & other goodies

Here's some of those pics:


Cut a channel for the wires to run through this:

_________________
Custom Bumper & Rock Rails-JBA 4.5" Lift-Custom 4.5" HD Springs-16x8 M13 Rims-265/75 Pro Comp MT2s-Yukon 4.56s-Front DTT-Rear OX Air Locker