LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

cruise control
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=1&t=8880
Page 1 of 1

Author:  liberated4life [ Wed May 24, 2006 2:47 pm ]
Post subject:  cruise control

This might be a tough one unless you really know kj's. My kj wasn't equipped with cruise control. I want to know if jeeps are prewired for cruise or not and if it is do I need to just replace the steering wheel and get a cc module. Any help on the subject would be hugely appreciated.

Author:  BCool [ Wed May 24, 2006 2:49 pm ]
Post subject: 

I think someone tried to add it and deemed it way too costly.

Author:  valvestem [ Wed May 24, 2006 2:57 pm ]
Post subject:  Re: cruise control

liberated4life wrote:
This might be a tough one unless you really know kj's. My kj wasn't equipped with cruise control. I want to know if jeeps are prewired for cruise or not and if it is do I need to just replace the steering wheel and get a cc module. Any help on the subject would be hugely appreciated.


It depends on what year your Jeep is. Most only needed to change the clockspring, add the cruise button, and add the CC module plus a couple other small things. Some years did not come with a preinstalled part (name escapes me right now) under the hood needed to make everything work.

Author:  liberated4life [ Wed May 24, 2006 3:34 pm ]
Post subject: 

its a 2004 if that helps

Author:  KJ-BOL [ Wed May 24, 2006 4:38 pm ]
Post subject: 

This is what dealership told me once when I wanted to install a cruise control - not aftermarket install - but factory - or under factory specs.
If the jeep is pre-wired then It can be done - if it is not prewired then It cannot

Author:  liberated4life [ Wed May 24, 2006 4:52 pm ]
Post subject: 

lol go figure huh. well i will have to find out if it's prewired and what/where to look for it

Author:  2006KJSPORT4x4 [ Wed May 24, 2006 5:16 pm ]
Post subject:  2006 model

I have a 2006 w/out CC and they(my dealer) quoted me a price of $232 and change to install WITH installation cost included. I am finding that hard to believe so I'm asking them to put it in writing so when I find time to get it I have the price they quoted me.

Author:  KJ-BOL [ Wed May 24, 2006 6:42 pm ]
Post subject: 

liberated4life wrote:
lol go figure huh. well i will have to find out if it's prewired and what/where to look for it


what do you have to look for?
I do not know, but my dealer took one simple look on the DRIVERS side and said... no you are not pre-wired

Author:  Average Joseph [ Wed May 24, 2006 7:10 pm ]
Post subject: 

I have an '03 sport w/o cruise and have been told I'm not wired by the dealer. They also told me Jeep used to make a kit for people like me, but no more :evil: .

It took a little doing, but I found a speedo shop with a knowledgeable staff (surprise!) who said all I need is a universal kit with a couple "special" adaptors. They want $450.00 though, but they're the only ones who want to take on the project... Captive audience. Whatayagonnado?

P.S. $232.00 sounds like a steal!!! Definately get it in wrighting.

Author:  Boi1ermaker [ Wed May 24, 2006 7:17 pm ]
Post subject: 

jparts carries three speed control kits, one for the 2.4L (04-05), one for the 3.7 (02-05) and one for the '06 3.7L. Not much info on their site, but do those also require the vehicle to be prewired in order to work?

Author:  liberated4life [ Wed May 24, 2006 8:01 pm ]
Post subject: 

with the kit that you found for 450$ was it using an aftermarket controller because i want to use the steering wheel controls. I really would like a factory look on the inside ya know?

Author:  PitViper [ Wed May 24, 2006 8:37 pm ]
Post subject: 

Part # 82207313 3.7-liter engines, complete kit. See footnote. $235.00

(1)Servo Connecter is not on vehicles built between 3/20/2003 and 3/12/2004. Check for presence of servo connector before ordering or installing. Do not attempt to install on vehicles built without it

Author:  Average Joseph [ Wed May 24, 2006 8:58 pm ]
Post subject: 

Quote:
(1)Servo Connecter is not on vehicles built between 3/20/2003 and 3/12/2004
This is me.

Just to clairify, it'll be $450 out the door (kit, extra parts & install).

The kit I'm getting is universal i.e. probably won't look that great. I really don't care though, as long as it works well. I'll be driving from S.D. to D.C. in a month so pragmatism takes prededence. Don't think I have a choice anyway... I could be wrong, but unless you're prewired you're probably in the same boat too :cry:

Author:  djformi [ Tue Jun 13, 2006 2:14 pm ]
Post subject:  cruise

Hey check out www.factorycustoms.com you can email denver with some requests and he has pretty decent prices. He has the cruise kit for libertys 181.00 installed but thats if you live near his shop.

Author:  Average Joseph [ Fri Jun 16, 2006 5:25 am ]
Post subject:  Got it Installed!

I finally got my universal kit installed today. Total cost was $445 and change. Sounds kinda steep I know, but I'm pretty sure this was my only option especially considering that the place where I got it done was the only one who would even toucdh it... plus they had done a KJ like mine (w/o pre-wired) a few week prior. Kit alone was $280+ (extra $30 part was needed).

The good part: It works great!!! Really smooth engagement and acceleration. Also, the joystick, conspicuous as it is, is fully adjustable and surprisingly ergonomic... Now all I need is a sunroof!

Image
Image

Author:  liberated4life [ Mon Jun 19, 2006 1:47 pm ]
Post subject:  Re: Got it Installed!

[quote="Average Joseph"]I finally got my universal kit installed today. Total cost was $445 and change. Sounds kinda steep I know, but I'm pretty sure this was my only option especially considering that the place where I got it done was the only one who would even toucdh it... plus they had done a KJ like mine (w/o pre-wired) a few week prior. Kit alone was $280+ (extra $30 part was needed).

Can you get any pics so that i can see if it will work for me? :D

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/