I put this aside for a month to work on zj but finished welding today.

_________________
2002 KJ prelowered with 3 1/2" daystar, 3/4" clevis, ome front shocks,Rancho rear shocks, 265/75/16 with 7/15" wheel spacers,homemade roof rack,alpine in-dash DVD touch screen,alpine aftermarket door speakers all around, 2 10" kicker crv's w/Rockford 800.1 amp.

nice job thats looks awesome,

_________________
'06 KJ SPORT 3.7L

Thanks! It was actually pretty easy. And all it cost me was about $30! I had some old bed frames and I bought 1" emt for crossmembers ($5) and some angle iron from Lowe's ($20)and misc.hardware.

_________________
2002 KJ prelowered with 3 1/2" daystar, 3/4" clevis, ome front shocks,Rancho rear shocks, 265/75/16 with 7/15" wheel spacers,homemade roof rack,alpine in-dash DVD touch screen,alpine aftermarket door speakers all around, 2 10" kicker crv's w/Rockford 800.1 amp.

Looks good! That is the exact same idea i had in my head with the bed frame angle and conduit.
How are you going to mount it?

_________________
2010 KK 4WD BRILLIANT BLACK
Fox/King/Bilstein ATH BUMPERS ATH RACK GY DURATRACS

ATHFAB.com

Well I made it just as long as the factory roof rails so I could drill through the ends where it mounts to the roof because those are more sturdy then the rails themselves. And I'll weld a nut on the inside of the rack so all I have to do is slide the bolt through the factory roof rail ends and into roof rack and tighten her up. It will also make for easy removal. Its very strong as well,I actually drove my zj over it and it held it yep no problems. I'm happy with it. The only thing I'll add is a antenna mount and a mount for 4 lights up front.Thanks for the compliment,I'm surprised there's no haters yet.lol

_________________
2002 KJ prelowered with 3 1/2" daystar, 3/4" clevis, ome front shocks,Rancho rear shocks, 265/75/16 with 7/15" wheel spacers,homemade roof rack,alpine in-dash DVD touch screen,alpine aftermarket door speakers all around, 2 10" kicker crv's w/Rockford 800.1 amp.

finished!!

_________________
2002 KJ prelowered with 3 1/2" daystar, 3/4" clevis, ome front shocks,Rancho rear shocks, 265/75/16 with 7/15" wheel spacers,homemade roof rack,alpine in-dash DVD touch screen,alpine aftermarket door speakers all around, 2 10" kicker crv's w/Rockford 800.1 amp.

Nice and low good job

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Thanks. I have self tapping screws ill drill from the inside of bottom cage into rails. I didn't know that the rails were reinforced through the whole middle until I started drilling ,which was a nice surprise . I plan on welding in a light bar and cb antenna tab as well,just want to run it for a week or so and see how wind affects it on the highway. I might have to put a "xterra" like rack fabbing on the front. We'll see. Thanks again for the props.

_________________
2002 KJ prelowered with 3 1/2" daystar, 3/4" clevis, ome front shocks,Rancho rear shocks, 265/75/16 with 7/15" wheel spacers,homemade roof rack,alpine in-dash DVD touch screen,alpine aftermarket door speakers all around, 2 10" kicker crv's w/Rockford 800.1 amp.