| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| OME Lift http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=12086 |
Page 1 of 1 |
| Author: | kj@best [ Tue Sep 05, 2006 3:48 pm ] |
| Post subject: | OME Lift |
Why don't we all just buy OME HD Springs all around $220 inc. shipping, and some longer rear shocks $35. Now we have a good lift for $255. Unless the front shocks are blown why buy new ones? |
|
| Author: | KJ04 [ Tue Sep 05, 2006 7:58 pm ] |
| Post subject: | Re: OME Lift |
kj@best wrote: Why don't we all just buy OME HD Springs all around $220 inc. shipping, and some longer rear shocks $35. Now we have a good lift for $255. Unless the front shocks are blown why buy new ones?
Keep the "we all" to "you all", and you get um! Most people aren't |
|
| Author: | Jeepjeepster [ Tue Sep 05, 2006 8:03 pm ] |
| Post subject: | |
Thats what i did, except it cost me alot more b/c I got the front ome struts and rear ome shocks. |
|
| Author: | Goglio704 [ Tue Sep 05, 2006 8:58 pm ] |
| Post subject: | |
Who sells O.M.E stuff? I know AllJ's does as part of a Frankenlift, but do they sell just the coil lift without the "Franken" extras? |
|
| Author: | Jeepjeepster [ Tue Sep 05, 2006 9:01 pm ] |
| Post subject: | |
Goglio704 wrote: Who sells O.M.E stuff? I know AllJ's does as part of a Frankenlift, but do they sell just the coil lift without the "Franken" extras?
Yea, thats where i got my rear ome coils. |
|
| Author: | tommudd [ Tue Sep 05, 2006 9:22 pm ] |
| Post subject: | |
All Js will sell you the springs by themselves if ya want them. I got mine there along with the Rancho Struts, did go closer to home to get the rear shocks, If you get them go with Heavy Dutys, ride is somewhat harder but not that bad on the road. |
|
| Author: | Jeepjeepster [ Tue Sep 05, 2006 9:36 pm ] |
| Post subject: | |
All they sell is the rear HD springs, not to sure about the fronts. I would not get the rear ome shocks. They ride great, but do not let it flex very much at all. Get the rancho rear shocks if you want flex. |
|
| Author: | kolesy [ Tue Sep 05, 2006 11:56 pm ] |
| Post subject: | |
Rusty's also sells the OME stuff as well. |
|
| Author: | cowdogg [ Thu Sep 07, 2006 8:12 pm ] |
| Post subject: | Re: OME Lift |
kj@best wrote: Why don't we all just buy OME HD Springs all around $220 inc. shipping,
I like this idea with the addition of rear Rancho rsx17004 ($112) and daystar bumpstops ($25), front Rancho rsx17505 ($164) and Rusty's strut plates ($30). Now I am looking at a pretty good setup for $551. Any more opinions? Good, bad or otherwise? |
|
| Author: | Edwin [ Fri Sep 08, 2006 8:04 pm ] |
| Post subject: | |
I got my OME HD springs from All J and my Ranchos too. I got 2.5" of lift. |
|
| Author: | Fouros [ Fri Sep 08, 2006 8:48 pm ] |
| Post subject: | |
i was running OME MD springs with the factory struts for a while and i would NOT recomend it, it made the front end WAY too stiff, while your pulling the front apart just replace the factory strut with a Rancho RSX17505 your KJ and kidneys will love you for it |
|
| Author: | sdeuel [ Sun Oct 01, 2006 12:24 pm ] |
| Post subject: | |
I got my OME stuff from Rocky Road Outfitters |
|
| Author: | JeepnJer [ Sun Oct 01, 2006 4:18 pm ] |
| Post subject: | OME HD |
Very happy with my OME HD springs from All J's, pre-assembled. Still sitting at 2.5 inches front and rear after a couple of weeks driving and a couple trips off road. Ride is great - not much stiffer than stock. Whether it settles any further over time remains to be seen, but if it stays over 2 inches I'll be happy. Also like the daystar bumpstops... they prevent the rear tires from stuffing too deep in the wheel wells. More room for larger tires! |
|
| Author: | Matt400 [ Sun Oct 01, 2006 5:41 pm ] |
| Post subject: | Re: OME Lift |
kj@best wrote: Unless the front shocks are blown why buy new ones?
Its an ideal time to replace if you have some miles on them and are doing a spring lift since they are being removed anyway. The ones I got from Rusty were .5" longer than stock so I suppose travel is increased a little out at the wheel. |
|
| Author: | warblade666 [ Mon Oct 02, 2006 12:56 am ] |
| Post subject: | |
I have heard that the OME springs are suposed to "settle" to about 1.5"-1.75" after a wile, but I don't know if thats compared to '02 pre-lowered ride hight or '03 up post-lowered ride hight. If it's '02 then the '03 and up would be about 2.0"-2.25". I just ordered the Skyjacker rear springs from Summit Racing on Sat,30th. |
|
| Author: | Edwin [ Mon Oct 02, 2006 6:59 am ] |
| Post subject: | Re: OME HD |
JeepnJer wrote: Very happy with my OME HD springs from All J's, pre-assembled. Still sitting at 2.5 inches front and rear after a couple of weeks driving and a couple trips off road. Ride is great - not much stiffer than stock. Whether it settles any further over time remains to be seen, but if it stays over 2 inches I'll be happy. Also like the daystar bumpstops... they prevent the rear tires from stuffing too deep in the wheel wells. More room for larger tires!
So wich lift did you get? The Frankenlift, or the OME HD? |
|
| Author: | JeepnJer [ Mon Oct 02, 2006 3:21 pm ] |
| Post subject: | OME HD |
I wasn't comfortable with the steep CV angles of the F-lift, so I went with the OME HD springs F/R, plus I did a quarter inch clevis lift which apparently gave me another half inch of lift. Sure was happy to see the ground clearance under the front skid plate go from 6.5" up to 9". Now the front has better clearance than the rear diff (except for those lower A-arms). Edwin, you've had your OME HD for almost a year now, right... how much has it settled? Jerry |
|
| Author: | Jeepjeepster [ Mon Oct 02, 2006 3:34 pm ] |
| Post subject: | Re: OME HD |
JeepnJer wrote: I wasn't comfortable with the steep CV angles of the F-lift, so I went with the OME HD springs F/R, plus I did a quarter inch clevis lift which apparently gave me another half inch of lift. Sure was happy to see the ground clearance under the front skid plate go from 6.5" up to 9". Now the front has better clearance than the rear diff (except for those lower A-arms).
Edwin, you've had your OME HD for almost a year now, right... how much has it settled? Jerry What front shocks did you go with? Do you get Upper ball joint contact? Ive done a very small(1/8in) clevis lift and cannot get anymore withough the Upper ball joint hitting. I wish there was some way to make a bump stop likes on the franken lift, but since the spacer isnt there, theres nothing to clamp to.. |
|
| Author: | JeepnJer [ Mon Oct 02, 2006 3:53 pm ] |
| Post subject: | Re: OME HD |
[/quote] What front shocks did you go with? Do you get Upper ball joint contact? Ive done a very small(1/8in) clevis lift and cannot get anymore withough the Upper ball joint hitting. I wish there was some way to make a bump stop likes on the franken lift, but since the spacer isnt there, theres nothing to clamp to.. Jeepster... I went with the OME struts which are pretty much the same as the Ranchos. I did get pass. side Upper BJ to strut contact the first time I went over a speed bump a little too fast. No problem off road so far, but I tend to 'wheel really slow in the rough stuff. About a year ago I saw someone on L.O.S.T. had made their own rubber bump stop and fastened it to the upper part of the knuckle where it contacted the strut. I might try something like that if I get any more contact. |
|
| Author: | Edwin [ Mon Oct 02, 2006 6:43 pm ] |
| Post subject: | Re: OME HD |
JeepnJer wrote: I wasn't comfortable with the steep CV angles of the F-lift, so I went with the OME HD springs F/R, plus I did a quarter inch clevis lift which apparently gave me another half inch of lift. Sure was happy to see the ground clearance under the front skid plate go from 6.5" up to 9". Now the front has better clearance than the rear diff (except for those lower A-arms).
Edwin, you've had your OME HD for almost a year now, right... how much has it settled? Jerry It's settled from 2-3/4" to 2.5". About 1/4 to 3/8". |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|