| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Noisy rear shocks? It's driving me crazy! http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=12997 |
Page 1 of 1 |
| Author: | sdeuel [ Sun Oct 01, 2006 12:27 pm ] |
| Post subject: | Noisy rear shocks? It's driving me crazy! |
I have a Rockfather I setup, with Doestch Tech 3000 shocks in the back. Ever since they were installed, I hear a rattling coming from the passenger side, rear wheel wheel area. It's hard to tell, but I think it's the shock mount rattling around. Anyone else have that problem? Is there a way to fix it or should I get a different shock? Thanks |
|
| Author: | Calvin56 [ Sun Oct 01, 2006 12:38 pm ] |
| Post subject: | |
Check the bolt going through the top, it usually needs to be tightened down. I swore I had tightened mine down, but I was getting a bumping sound. I tightened it down more and it went away. A couple people have also put some washers in the shock mount as well. Good luck! |
|
| Author: | gastip [ Sun Oct 01, 2006 5:08 pm ] |
| Post subject: | |
I think Calvin is right sdeuel. When I torqued mine down to the specs in my install instructions, the tabs the shock mount goes between actually bent in to meet it a little. I've had no noise at all. I've also heard of people shimming with washers to prevent the shock from sliding back and forth on the bolt. |
|
| Author: | sdeuel [ Sun Oct 01, 2006 10:10 pm ] |
| Post subject: | |
So you think it's the back and forth motion of the shock mount, not up and down? By putting washers on the side of the mount I could see where it would help if the side-to-side motion was a problem - is it possible it's an up-down motion? |
|
| Author: | Jeepjeepster [ Sun Oct 01, 2006 10:31 pm ] |
| Post subject: | |
It could be either. If its not tight side-to-side then it will make noise when the shock goes up and down... |
|
| Author: | MoladoGuy [ Sun Oct 01, 2006 11:09 pm ] |
| Post subject: | |
Dont know if this helps cause I have the RSX17004 rear shocks but I used 4 washers for the top on each side to eliminate any squeaking and movement. |
|
| Author: | warblade666 [ Mon Oct 02, 2006 12:46 am ] |
| Post subject: | |
I have seen some of the aftermarket shocks that the upper bushing is for a 12mm or 14mm bolt. I beleave the KJ's is only 10mm, that will make some noise. |
|
| Author: | kolesy [ Mon Oct 02, 2006 6:00 am ] |
| Post subject: | |
Yep jsut place a couple washers up in there for some shims. I had the same problem with the rustys shocks. I didnt want to over torque the bolt down and bend the shock mounts in so I added a couple washers and problem solved. |
|
| Author: | TDI4BY [ Tue Oct 03, 2006 4:10 am ] |
| Post subject: | |
warblade666 wrote: I have seen some of the aftermarket shocks that the upper bushing is for a 12mm or 14mm bolt. I beleave the KJ's is only 10mm, that will make some noise.
That is what I found too, I just put some shim stock around the bolt to take up the slack. I will try to post a pic. I took a Chevy starter shim and cut a piece off, hammered it around the bolt and then slid it together. Worked perfect. The shock knock is definately from the up down movement not side to side. I did use a few washers on the side too first but the shimmed bolt actually fixed the noise. .......Knock,knock'a,knock'a knock.rattle, knocka, knock.............. |
|
| Author: | JFortier777 [ Tue Oct 03, 2006 11:55 am ] |
| Post subject: | Re: Noisy rear shocks? It's driving me crazy! |
sdeuel wrote: I have a Rockfather I setup, with Doestch Tech 3000 shocks in the back. Ever since they were installed, I hear a rattling coming from the passenger side, rear wheel wheel area. It's hard to tell, but I think it's the shock mount rattling around. Anyone else have that problem? Is there a way to fix it or should I get a different shock?
Thanks LOL!!!!!!!!! It sounds like a bucket of sockets bouncing and rolling around doesn't it? I nearly struck my friend in the forehead with a meat cleaver because it was driving me so crayZ. But yeah its been cured, either add washers or tighten down a LOT. Personally I prefer the latter. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|